CC3120MOD Datasheet, PDF (30/52 Pages) Texas Instruments – SimpleLink Wi-Fi CERTIFIED Network Processor Internet-of-Things Module Solution for MCU Applications

CC3120MOD
SWRS205 – MARCH 2017
www.ti.com
6.5 Restoring Factory Default Configuration
The device has an internal recovery mechanism that allows rolling back the file system to its predefined
factory image or restoring the factory default parameters of the device. The factory image is kept in a
separate sector on the sFLASH in a secure manner and cannot be accessed from the host processor. The
following restore modes are supported:
• None—no factory restore settings
• Enable restore of factory default parameters
• Enable restore of factory image and factory default parameters
The restore process is performed by pulling or forcing SOP[2:0] = 110 pins and toggling the nRESET pin
from low to high.
The process is fail-safe and resumes operation if a power failure occurs before the restore is finished. The
restore process typically takes about 8 seconds, depending on the attributes of the serial flash vendor.
6.6 Certification
The CC3120MOD module is certified to the standards listed in Table 6-2 (with IDs where applicable):
REGULATORY BODY
FCC (USA)
IC (Canada)
ETSI/CE (Europe)
Japan MIC
SRRC (China)
Table 6-2. CC3120MOD List of Certifications
SPECIFICATION
ID (IF APPLICABLE)
Part 15C + MPE FCC RF Exposure
TBD
RSS-102 (MPE) and RSS-247 (Wi-Fi)
TBD
EN300328 v2.1.1 (2.4 GHz Wi-Fi)
—
EN62311:2008 (MPE)
—
EN 301489-1 v2.1.1 (EMC General)
—
EN301489-17 v3.1.1 (EMC Wi-Fi)
—
EN50024:2010/A1:2015
—
EN55032:2012/AC:2013
—
EN 60950-
—
1:2006/A11:2009/A1:2010/A12:2011/A2:2013
TBD
TBD
TBD
TBD
6.6.1 Federal Communications Commission Statement
You are cautioned that changes or modifications not expressly approved by the part responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired
operation of the device.
CAUTION
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure limits. This transmitter must not be
colocated or operating with any other antenna or transmitter.
30
Detailed Description
Submit Documentation Feedback
Product Folder Links: CC3120MOD
Copyright © 2017, Texas Instruments Incorporated