LM3S613 Datasheet, PDF (234/591 Pages) List of Unclassifed Manufacturers – Microcontroller

General-Purpose Input/Outputs (GPIOs)
7.3 Functional Description
Important: All GPIO pins are inputs by default (GPIODIR=0 and GPIOAFSEL=0), with the exception
of the five JTAG pins (PB7 and PC[3:0]). The JTAG pins default to their JTAG
functionality (GPIOAFSEL=1). A Power-On-Reset (POR) or asserting an external reset
(RST) puts both groups of pins back to their default state.
While debugging systems where PB7 is being used as a GPIO, care must be taken to
ensure that a Low value is not applied to the pin when the part is reset. Because PB7
reverts to the TRST function after reset, a Low value on the pin causes the JTAG
controller to be reset, resulting in a loss of JTAG communication.
Each GPIO port is a separate hardware instantiation of the same physical block (see Figure
7-2 on page 234). The LM3S613 microcontroller contains five ports and thus five of these physical
GPIO blocks.
Figure 7-2. GPIO Port Block Diagram
Mode
Control
GPIOAFSEL
Alternate Input
Alternate Output
Alternate Output Enable
Data
Control
GPIODATA
GPIODIR
GPIO Input
GPIO Output
GPIO Output Enable
Pad Input
Pad Output
Pad Output Enable
Digital
I/O Pad
Package I/O Pin
Interrupt
Interrupt
Control
GPIOIS
GPIOIBE
GPIOIEV
GPIOIM
GPIORIS
GPIOMIS
GPIOICR
Pad
Control
GPIODR2R
GPIODR4R
GPIODR8R
GPIOSLR
GPIOPUR
GPIOPDR
GPIOODR
GPIODEN
Identification Registers
GPIOPeriphID0
GPIOPeriphID1
GPIOPeriphID2
GPIOPeriphID3
GPIOPeriphID4
GPIOPeriphID5
GPIOPeriphID6
GPIOPeriphID7
GPIOPCellID0
GPIOPCellID1
GPIOPCellID2
GPIOPCellID3
7.3.1
Data Control
The data control registers allow software to configure the operational modes of the GPIOs. The data
direction register configures the GPIO as an input or an output while the data register either captures
incoming data or drives it out to the pads.
234
July 14, 2014
Texas Instruments-Production Data