English
Language : 

BQ25606 Datasheet, PDF (22/43 Pages) Texas Instruments – Standalone 3.0-A, Single Cell Battery Charger With 40V Over Voltage Protection Controller
bq25606
SLUSCK6 – MAY 2017
Voltage
9V
3.6V
3.4V
3.2V
3.18V
VBUS
SYS
BAT
www.ti.com
Current
4A
3.2A
2.8A
ISYS
ICHG
1.2A
IIN
1.0A
0.5A
-0.6A
DPM
DPM
Supplement
Figure 16. DPM Response
8.3.6.9 Supplement Mode
When the system voltage falls 180 mV (VBAT > VSYSMin) or 45 mV (VBAT < VSYSMin) below the battery
voltage, the BATFET turns on and the BATFET gate is regulated the gate drive of BATFET so that the minimum
BATFET VDS stays at 30 mV when the current is low. This prevents oscillation from entering and exiting the
supplement mode.
As the discharge current increases, the BATFET gate is regulated with a higher voltage to reduce RDSON until
the BATFET is in full conduction. At this point onwards, the BATFET VDS linearly increases with discharge
current. Figure 17 shows the V-I curve of the BATFET gate regulation operation. BATFET turns off to exit
supplement mode when the battery is below battery depletion threshold.
4.5
4
3.5
3
2.5
2
1.5
1
0.5
0
0
5 10 15 20 25 30 35 40 45 50 55
V(BAT-SYS) (mV)
D001
Plot1
Figure 17. BAFET V-I Curve
8.3.7 Status Outputs (PG, STAT)
8.3.7.1 Power Good indicator (PG Pin)
The PG pin goes LOW to indicate a good input source when:
22
Submit Documentation Feedback
Product Folder Links: bq25606
Copyright © 2017, Texas Instruments Incorporated