OPA316_16 Datasheet, PDF (21/48 Pages) Texas Instruments – 10-MHz, Low-Power, Low-Noise, RRIO, 1.8-V CMOS Operational Amplifier

www.ti.com
OPA316, OPA2316, OPA2316S, OPA4316
SBOS703E – APRIL 2014 – REVISED JUNE 2016
8.2 Typical Application
Some applications require differential signals. Figure 41 shows a simple circuit to convert a single-ended input of
0.1 V to 2.4 V into a differential output of ±2.3 V on a single 2.7-V supply. The output range is intentionally limited
to maximize linearity. The circuit is composed of two amplifiers. One amplifier functions as a buffer and creates a
voltage, Vout+. The second amplifier inverts the input and adds a reference voltage to generate Vout–. Both
Vout+ and Vout– range from 0.1 V to 2.4 V. The difference, Vdiff, is the difference between Vout+ and Vout–
which makes the differential output voltage range 2.3 V.
R₂
R₁
R₃
2.7V
-+
+
Vout-
2.7V
-+
Vref
2.5V
R₄
V ^Vdiff
+
Vout+
+
Vin
Figure 41. Schematic for a Single-Ended Input to Differential Output Conversion
8.2.1 Design Requirements
Table 1 lists the design requirements:
Table 1. Design Parameters
DESIGN PARAMETER
Supply voltage
Reference voltage
Input voltage
Output differential voltage
Output common-mode voltage
Small-signal bandwidth
VALUE
2.7 V
2.5 V
0.1 V to 2.4 V
±2.3 V
1.25 V
5 MHz
8.2.2 Detailed Design Procedure
The circuit in Figure 41 takes a single-ended input signal, Vin, and generates two output signals, Vout+ and
Vout– using two amplifiers and a reference voltage, Vref. Vout+ is the output of the first amplifier and is a
buffered version of the input signal, Vin (as shown in Equation 1). Vout– is the output of the second amplifier
which uses Vref to add an offset voltage to Vin and feedback to add inverting gain. The transfer function for
Vout– is given in Equation 2.
Vout Vin
(1)
Copyright © 2014–2016, Texas Instruments Incorporated
Submit Documentation Feedback
21
Product Folder Links: OPA316 OPA2316 OPA2316S OPA4316