English
Language : 

TLK2201A_16 Datasheet, PDF (15/20 Pages) Texas Instruments – ETHERNET TRANSCEIVERS
www.ti.com
TLK2201A
TLK2201AI
SLLS572B – JUNE 2003 – REVISED SEPTEMBER 2007
Host
Protocol
Device
JTAG
Controller
2.5 V
5 Ω at 100 MHz
2.5 V
VDD VDDA
18
VDDPLL
0.01 µF
GND
GNDPLL 64
GNDA
TLK2201A
TLK2201AI
17
TESTEN
10
TD0−TD9
TXP 62
22
REFCLK
16
PRBSEN
19
LOOPEN
24
SYNCEN
TXN 61
47 SYNC/PASS
10
RD0−RD9
2
RBC0−RBC1
28
ENABLE
RXP 54
26 LOS
32
RBCMODE
15
MODESEL
49
TCK
55
JTMS
48
JTDI
56
JTRSTN
Rt 50 Ω
Rt
RXN 52
50 Ω
27 JTDO
Controlled Impedance
Transmission Line
Controlled Impedance
Transmission Line
Controlled Impedance
Transmission Line
Controlled Impedance
Transmission Line
Figure 12. Typical Application Circuit (AC mode)
DESIGNING WITH PowerPAD™
The TLK2201A and TLK2201AI are housed in a high performance, thermally enhanced, 64-pin VQFP (RCP64)
PowerPAD package. Use of the PowerPAD package does not require any special considerations except to note
that the PowerPAD, which is an exposed die pad on the bottom of the device, is a metallic thermal and electrical
conductor. Therefore, if not implementing PowerPAD PCB features, the use of solder masks (or other assembly
techniques) may be required to prevent any inadvertent shorting by the exposed PowerPAD of connection etches
or vias under the package. It is strongly recommended that the PowerPAD be soldered to the thermal land. The
recommended convention, however, is to not run any etches or signal vias under the device, but to have only a
grounded thermal land as explained below. Although the actual size of the exposed die pad may vary, the
minimum size required for the keepout area for the 64-pin PFP PowerPAD package is 8 mm × 8 mm.
Copyright © 2003–2007, Texas Instruments Incorporated
Submit Documentation Feedback
15
Product Folder Link(s): TLK2201A TLK2201AI