MSP430X241X Datasheet, PDF (59/98 Pages) Texas Instruments – MIXED SIGNAL MICROCONTROLLER

MSP430x241x, MSP430x261x
MIXED SIGNAL MICROCONTROLLER
SLAS541A -- JUNE 2007 -- REVISED OCTOBER 2007
electrical characteristics over recommended ranges of supply voltage and operating free-air
temperature (unless otherwise noted) (continued)
Comparator_A+ (see Note 1)
PARAMETER
TEST CONDITIONS
VCC
MIN TYP MAX UNIT
I_(DD)
CAON = 1, CARSEL = 0, CAREF = 0
2.2 V
3V
25
40
μA
45
60
I_{(Refladder/Refdiode)}
V_(IC)
Common-mode input voltage
CAON = 1, CARSEL = 0,
CAREF = 1/2/3, no load at P2.3/CA0/TA1
and P2.4/CA1/TA2
CAON =1
2.2 V
3V
2.2 V/3 V
30
50
μA
45
71
0
V_CC--1 V
V_(Ref025)
V_(Ref050)
Voltage @ 0.25 VCC node
VCC
Voltage @ 0.5VCC node
VCC
PCA0 = 1, CARSEL = 1, CAREF = 1,
no load at P2.3/CA0/TA1 and
P2.4/CA1/TA2
PCA0 = 1, CARSEL = 1, CAREF = 2,
no load at P2.3/CA0/TA1 and
P2.4/CA1/TA2
2.2 V/3 V 0.23 0.24 0.25
2.2 V/3 V 0.47 0.48
0.5
V_(RefVT)
V_(offset)
V_hys
t_(response)
See Figure 35 and Figure 36
Offset voltage
PCA0 = 1, CARSEL = 1, CAREF = 3,
no load at P2.3/CA0/TA1 and
P2.4/CA1/TA2, T_A = 85°C
See Note 2
Input hysteresis
CAON=1
Response time, low-to-high and
high-to-low (see Note 3)
T_A = 25°C, Overdrive 10 mV,
Without filter: CAF = 0
T_A = 25°C, Overdrive 10 mV,
With filter: CAF = 1
2.2 V
3V
2.2 V/3 V
2.2 V/3 V
2.2 V
3V
2.2 V
3V
390 480
400 490
--30
0 0.7
80 165
70 120
1.4 1.9
0.9 1.5
540
mV
550
30 mV
1.4 mV
300
ns
240
2.8
μs
2.2
NOTES:
1. The leakage current for the Comparator_A+ terminals is identical to I_lkg(Px.x) specification.
2. The input offset voltage can be cancelled by using the CAEX bit to invert the Comparator_A+ inputs on successive measurements.
The two successive measurements are then summed together.
3. The response time is measured at P2.2/CAOUT/TA0/CA4 with an input voltage step, with Comparator_A+ already enabled
(CAON = 1). If CAON is set at the same time, a settling time of up to 300 ns is added to the response time.
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
59