THS6182_07 Datasheet, PDF (3/35 Pages) Texas Instruments – LOW-POWER DISSIPATION ADSL LINE DRIVER

THS6182
www.ti.com
SLLS544G – SEPTEMBER 2002 – REVISED NOVEMBER 2004
ABSOLUTE MAXIMUM RATINGS
over operating free-air temperature range unless otherwise noted⁽¹⁾
ELECTRICAL
V_CC
V_I
I_O
V_IO
THERMAL
Supply voltage
Input voltage
Output current
Differential input voltage
Maximum junction temperature, any condition
T_J
Maximum junction temperature, continuous operation, long term reliability ⁽²⁾
T_stg
Storage temperature
Lead temperature, 1,6 mm (1/16-inch) from case for 10 seconds
ESD
HBM
ESD ratings
CDM
MM
THS6132
±16.5 V
±V_CC
1000 mA
±2 V
150°C
125°C
65°C to 150°C
300°C
2000 V
1500 V
200 V
(1) The absolute maximum ratings under any condition is limited by the constraints of the silicon process. Stresses above these ratings may
cause permanent damage. Exposure to absolute-maximum-rated conditions for extended periods may degrade device reliability. These
are stress ratings only, and functional operation of the device at these or any other conditions beyond those ispecified is not implied.
(2) The maximum junction temperature for continuous operation is limited by package constraints. Operation above this temperature may
result in reduced reliability and/or lifetime of the device.
ELECTRICAL CHARACTERISTICS
over recommended operating free-air temperature range, T_A = 25°C, V_CC = ±12 V, R_F = 2 kΩ,
Gain = +5, I_ADJ = Bias1 = Bias2 = 0 V, R_L = 50 Ω (unless otherwise noted)
PARAMETER
TEST CONDITIONS
NOISE/DISTORTION PERFORMANCE
MTPR Multitone power ratio
Gain =+9.5, 163 kHz to 1.1 MHz DMT,
+20 dBm Line Power, See Figure 1 for circuit
Receive band spill-over
Gain =+5, 25 kHz to 138 kHz with MTPR signal applied,
See Figure 1 for circuit
HD
Harmonic distortion, V_O(PP) = 2 V
f = 1 MHz
2^nd harmonic
3^rd harmonic
Differential load = 200 Ω
Differential load = 50 Ω
Differential load = 200 Ω
Differential load = 50 Ω
V_n
Input voltage noise
+Input
I_n
Input current noise
-Input
V_CC = ±5 V, ±12 V, ±15 V, f = 100 kHz
V_CC = ±5 V, ±12 V, ±15 V, f = 100 kHz
Crosstalk
f = 1 MHz, V_O(PP) = 2 V,
V_CC = ±5 V, ±12 V, ±15 V
R_L = 100 Ω
R_L = 25 Ω
MIN TYP MAX UNIT
-76
-95
-88
-70
-107
-84
3.2
1.5
10
-65
-60
dBc
dBc
dBc
dBc
nV/√Hz
pA/√Hz
dBc
dBc
3