English
Language : 

BQ24616 Datasheet, PDF (29/34 Pages) Texas Instruments – JEITA Guideline Compatible Stand-Alone Synchronous Switch-Mode Li-Ion or Li-Polymer Battery Charger with System Power Selector and Low Iq
bq24616
www.ti.com
SLUSA49A – APRIL 2010 – REVISED MAY 2010
tie analog ground to power ground (PowerPAD should tie to analog ground in this case). A star-connection
under PowerPAD is highly recommended.
8. It is critical that the exposed PowerPAD on the backside of the IC package be soldered to the PCB ground.
Ensure that there are sufficient thermal vias directly under the IC, connecting to the ground plane on the
other layers.
9. Decoupling capacitors should be placed next to the IC pins and make trace connection as short as possible.
10. All via size and number should be enough for a given current path.
SW
L1
R1
VBAT
High
VIN
Frequency
Current
BAT
C1
Path
PGND
C2
C3
Figure 21. High Frequency Current Path
Current Direction
RSNS
Current Sensing Direction
To SRP - SRN pin or ACP - ACN pin
Figure 22. Sensing Resistor PCB Layout
Refer to the EVM design (SLUU396) for the recommended component placement with trace and via locations.
For the QFN information, refer to SCBA017 and SLUA271.
Copyright © 2010, Texas Instruments Incorporated
Product Folder Link(s): bq24616
Submit Documentation Feedback
29