AM1707 Datasheet, PDF (26/198 Pages) Texas Instruments – AM1707 ARM Microprocessor

AM1707
SPRS637 – FEBRUARY 2010
www.ti.com
3.6.13 Timers
Table 3-15. Timers Terminal Functions
SIGNAL NAME
PIN
No.
ZKB
TYPE ⁽¹⁾
PULL ⁽²⁾
MUXED
DESCRIPTION
TIMER0
UART0_RXD/I2C0_SDA/TM64P0_IN12/GP5[8]/BOOT[8]
UART0_TXD/I2C0_SCL/TM64P0_OUT12/GP5[9]/BOOT[9]
R3
I
P3
O
IPU
Timer0 lower input.
UART0, I2C0,
IPU ^{GPIO, BOOT}
Timer0 lower
output
TIMER1 (Watchdog )
No external pins. The Timer1 peripheral signals are not pinned out as external pins.
(1) I = Input, O = Output, I/O = Bidirectional, Z = High impedance, PWR = Supply voltage, GND = Ground, A = Analog signal.
Note: The pin type shown refers to the input, output or high-impedance state of the pin function when configured as the the signal name
highlighted in bold. All multiplexed signals may enter a high-impedance state when the configured function is input-only or the configured
function supports high-Z operation. All GPIO signals can be used as input or output. For multiplexed pins where functions have different
types (ie., input versus output), the table reflects the pin function direction for that particular peripheral.
(2) IPD = Internal Pulldown resistor, IPU = Internal Pullup resistor
26
Device Overview
Submit Documentation Feedback
Product Folder Link(s): AM1707
Copyright © 2010, Texas Instruments Incorporated