AM1810 Datasheet, PDF (23/259 Pages) Texas Instruments – AM1810 ARM Microprocessor For PROFIBUS

AM1810
www.ti.com
SPRS709B – NOVEMBER 2010 – REVISED DECEMBER 2011
2.7.6 DDR2 Controller (DDR2)
DDR_D[15]
DDR_D[14]
DDR_D[13]
DDR_D[12]
DDR_D[11]
DDR_D[10]
DDR_D[9]
DDR_D[8]
DDR_D[7]
DDR_D[6]
DDR_D[5]
DDR_D[4]
DDR_D[3]
DDR_D[2]
DDR_D[1]
DDR_D[0]
DDR_A[13]
DDR_A[12]
DDR_A[11]
DDR_A[10]
DDR_A[9]
DDR_A[8]
DDR_A[7]
DDR_A[6]
DDR_A[5]
DDR_A[4]
DDR_A[3]
DDR_A[2]
DDR_A[1]
DDR_A[0]
DDR_CLKP
DDR_CLKN
DDR_CKE
DDR_WE
DDR_RAS
DDR_CAS
DDR_CS
DDR_DQM[0]
DDR_DQM[1]
SIGNAL
NAME
Table 2-8. DDR2 Controller (DDR2) Terminal Functions
NO.
W10
U11
V10
U10
T12
T10
T11
T13
W11
W12
V12
V13
U13
V14
U14
U15
T5
V4
T4
W4
T6
U4
U6
W5
V5
U5
V6
W6
T7
U7
W8
W7
V7
T8
W9
U9
V9
W13
R10
TYPE⁽¹⁾ PULL⁽²⁾
DESCRIPTION
I/O
IPD
I/O
IPD
I/O
IPD
I/O
IPD
I/O
IPD
I/O
IPD
I/O
IPD
I/O
IPD
DDR2 SDRAM data bus
I/O
IPD
I/O
IPD
I/O
IPD
I/O
IPD
I/O
IPD
I/O
IPD
I/O
IPD
I/O
IPD
O
IPD
O
IPD
O
IPD
O
IPD
O
IPD
O
IPD
O
IPD
DDR2 row/column address
O
IPD
O
IPD
O
IPD
O
IPD
O
IPD
O
IPD
O
IPD
O
IPD DDR2 clock (positive)
O
IPD DDR2 clock (negative)
O
IPD DDR2 clock enable
O
IPD DDR2 write enable
O
IPD DDR2 row address strobe
O
IPD DDR2 column address strobe
O
IPD DDR2 chip select
O
IPD
DDR2 data mask outputs
O
IPD
(1) I = Input, O = Output, I/O = Bidirectional, Z = High impedance, PWR = Supply voltage, GND = Ground, A = Analog signal.
Note: The pin type shown refers to the input, output or high-impedance state of the pin function when configured as the signal name
highlighted in bold. All multiplexed signals may enter a high-impedance state when the configured function is input-only or the configured
function supports high-Z operation. All GPIO signals can be used as input or output. For multiplexed pins where functions have different
types (ie., input versus output), the table reflects the pin function direction for that particular peripheral.
(2) IPD = Internal Pulldown resistor; IPU = Internal Pullup resistor; CP[n] = configurable pull-up/pull-down (where n is the pin group) using
the PUPDENA and PUPDSEL registers in the System Module.
Copyright © 2010–2011, Texas Instruments Incorporated
Submit Documentation Feedback
Product Folder Link(s): AM1810
Device Overview
23