DRV103UG4 Datasheet, PDF (2/24 Pages) Burr-Brown (TI) – PWM LOW-SIDE DRIVER (1.5A and 3A) for Solenoids, Coils, Valves, Heaters, and Lamps

PACKAGE/ORDERING INFORMATION
PRODUCT
DRV103U
"
PACKAGE
SO-8
"
PACKAGE
DRAWING
NUMBER
182
"
SPECIFIED
TEMPERATURE
RANGE
–40°C to +85°C
"
PACKAGE
MARKING
DRV103U
"
ORDERING
NUMBER⁽¹⁾
DRV103U
DRV103U/2K5
TRANSPORT
MEDIA
Rails
Tape and Reel
DRV103H
"
PowerPAD™ SO-8
"
DDA
"
–40°C to +85°C
"
DRV103H
"
DRV103H
DRV103H/2K5
Rails
Tape and Reel
NOTES: (1) Models with a slash (/) are available only in Tape and Reel in the quantities indicated (e.g., /2K5 indicates 2500 devices per reel). Ordering 2500
pieces of “DRV103U/2K5” will get a single 2500-piece Tape and Reel.
ABSOLUTE MAXIMUM RATINGS⁽¹⁾
Supply Voltage, V_S(2) ......................................................................... +40V
Input Voltage .................................................................. –0.2V to +5.5V⁽³⁾
PWM Adjust Input .......................................................... –0.2V to +5.5V⁽³⁾
Delay Adjust Input .......................................................... –0.2V to +5.5V⁽³⁾
Frequency Adjust Input .................................................. –0.2V to +5.5V⁽³⁾
Status OK Flag and OUT .................................................... –0.2V to V_S(4)
Operating Temperature Range ...................................... –55°C to +125°C
Storage Temperature Range ......................................... –65°C to +150°C
Junction Temperature .................................................................... +150°C
Lead Temperature (soldering, 10s) ............................................... +300°C
NOTES: (1) Stresses above these ratings may cause permanent damage.
Exposure to absolute maximum conditions for extended periods may de-
grade device reliability. (2) See Bypassing section for discussion about
operating near maximum supply voltage. (3) Higher voltage may be applied
if current is limited to 2mA. (4) The Status OK Flag will internally current limit
at about 10mA.
ELECTROSTATIC
DISCHARGE SENSITIVITY
This integrated circuit can be damaged by ESD. Texas Instru-
ments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling
and installation procedures can cause damage.
ESD damage can range from subtle performance degradation
to complete device failure. Precision integrated circuits may
be more susceptible to damage because very small parametric
changes could cause the device not to meet its published
specifications.
2
DRV103
SBVS029A