TCA6408_09 Datasheet, PDF (14/31 Pages) Texas Instruments – LOW-VOLTAGE 8-BIT I2C AND SMBus I/O EXPANDER WITH INTERRUPT OUTPUT, RESET, AND CONFIGURATION REGISTERS

TCA6408
LOW-VOLTAGE 8-BIT I²C AND SMBus I/O EXPANDER
WITH INTERRUPT OUTPUT, RESET, AND CONFIGURATION REGISTERS
SCPS151C – FEBRUARY 2007 – REVISED JUNE 2007
www.ti.com
I²C Interface Timing Requirements
over recommended operating free-air temperature range (unless otherwise noted) (see Figure 10)
f_scl
t_sch
t_scl
t_sp
t_sds
t_sdh
t_icr
t_icf
t_ocf
t_buf
t_sts
t_sth
t_sps
t_vd(data)
t_vd(ack)
I²C clock frequency
I²C clock high time
I²C clock low time
I²C spike time
I²C serial data setup time
I²C serial data hold time
I²C input rise time
I²C input fall time
I²C output fall time; 10 pF to 400 pF bus
I²C bus free time between Stop and Start
I²C Start or repeater Start condition setup time
I²C Start or repeater Start condition hold time
I²C Stop condition setup time
Valid data time; SCL low to SDA output valid
Valid data time of ACK condition; ACK signal from SCL low to
SDA (out) low
STANDARD MODE
I²C BUS
MIN
MAX
0
100
4
4.7
0
50
250
0
1000
300
300
4.7
4.7
4
4
1
1
FAST MODE
I²C BUS
MIN
MAX
0
400
0.6
1.3
0
50
100
0
20 + 0.1C_b(1)
300
20 + 0.1C_b(1)
300
20 + 0.1C_b(1)
300
1.3
0.6
0.6
0.6
1
1
UNIT
kHz
µs
µs
ns
ns
ns
ns
ns
µs
µs
µs
µs
µs
µs
µs
(1) C_b = total capacitance of one bus line in pF
Reset Timing Requirements
over recommended operating free-air temperature range (unless otherwise noted) (see Figure 13)
t_W
t_REC
t_RESET
Reset pulse duration
Reset recovery time
Time to reset⁽¹⁾
STANDARD MODE
I²C BUS
MIN
MAX
4
0
600
FAST MODE
I²C BUS
MIN
MAX
4
0
600
(1) Minimum time for SDA to become high or minimum time to wait before doing a START
UNIT
ns
ns
ns
Switching Characteristics
over recommended operating free-air temperature range, C_L≤ 100 pF (unless otherwise noted) (see Figure 10)
PARAMETER
FROM
TO
STANDARD
MODE
I²C BUS
FAST MODE
I²C BUS
MIN MAX
MIN MAX
t_iv
Interrupt valid time
t_ir
Interrupt reset delay time
t_pv
Output data valid
t_ps
Input data setup time
t_ph
Input data hold time
P Port
SCL
SCL
P Port
P Port
INT
INT
P7–P0
SCL
SCL
4
4
4
4
400
400
0
0
300
300
UNIT
µs
µs
ns
ns
ns
14
Submit Documentation Feedback