108-1228 Datasheet, PDF (2/7 Pages) TE Connectivity Ltd – Signal application only, 1 ampere maximum at 50% energized, See Figure 2.

3.4. Performance and Test Description
108-1228
Product is designed to m eet the electrical, m echanical and environm ental perform ance requirem ents
specified in Figure 1. Unless otherwise specified, all tests shall be perform ed at am bient environm ental
conditions per Test Specification 109-1.
3.5. Test Requirem ents and Procedures Sum m ary
Test Description
Examination of product.
Termination resistance.
Insulation resistance.
Dielectric withstanding voltage.
Capacitance.
Vibration, random.
Physical shock.
Durability.
R equirem ent
Procedure
Meets requirements of product
Visual, dim ensional and functional
drawing and Application Spec 114- per applicable quality inspection
40029.
plan.
ELECTRICAL
25 milliohms maximum.
TE Spec 109-6-1.
Subject mated contacts assembled
in housing to 50 mv maximum open
circuit at 100 ma maximum.
See Figure 5.
1000 megohms minimum.
TE Spec 109-28-4.
Test between adjacent contacts of
m ated sam ples.
500 vac at sea level.
TE Spec 109-29-1.
Test between adjacent contacts of
m ated sam ples.
3 picofarads maximum.
TE Spec 109-47, Condition E.
Test between adjacent circuits of
m ated sam ples.
MECHANICAL
No discontinuities of 1 microsecond
or longer duration.
See Note.
TE Spec 109-21-5.
Subject m ated sam ples to 7.3 G's
rms. 20 minutes in each of 3
m utually perpendicular planes.
See Figures 6 and 7.
No discontinuities of 1 microsecond
or longer duration.
See Note.
TE Spec 109-26-1, except 30 G's.
Subject m ated sam ples to 30 G's
half-sine shock pulses of 11
m illiseconds duration. 3 shocks in
each direction applied along 3
m utually perpendicular planes, 18
total shocks.
See Figures 6 and 7.
See Note.
TE Spec 109-27.
Mate and unmate samples without
locking latches for 500 cycles at
maximum rate of 800 cycles per
hour.
Figure 1 (continued)
Rev F
2 of 7