C5750X7R1H106M Datasheet, PDF (68/72 Pages) TDK Electronics – C Series General Application

General
Specifications
C Series – General Application
No. Item
Performance
Test or Inspection Method
17
Life
External
appearance
Capacitance
Q
(Class 1)
No mechanical damage.
Characteristics
Change from the
value before test
Class 1 C0G
±3% or ±0.3pF,
whichever larger.
Class 2 X5R
X7R
Y5V
± 25 %
± 25 %
± 30 %
*(± 40 %)
* Inside ( ) is applied to Y5V 6.3V
product.
Rated
Q
Capacitance
C ≥ 30pF
350 min.
10pF ≤ C < 30pF 275+5/2×C min.
C < 10pF
200+10×C min.
C : Rated capacitance (pF)
Reflow solder the capacitor on P.C. board (shown in
Appendix 1a or Appendix 1b) before testing.
Apply voltage at 125±2ºC for 1,000 +48, 0h.
Applied voltage is 1xRV. Some items may be tested at
higher voltage (1.2x, 1.5x or 2xRV).
Charge/discharge current shall not exceed 50mA.
Leave the capacitors in ambient condition for 6 to 24h
(Class 1) or 24±2h (Class 2) before measurement.
Voltage conditioning (only for class 2) Voltage treat the
capacitor under testing temperature and voltage for 1
hour.
Leave the capacitor in ambient conditions for 24±2h
before measurement.
Use this measurement for initial value.
D.F.
(Class 2)
Characteristics
X5R: 200% of initial spec. max.
X7R: 200% of initial spec. max
Y5V: 150% of initial spec. max
Insulation
Resistance
1,000MΩ or 50MΩ•μF min. , whichever
smaller.
(As for the capacitors of rated voltage
16, 10 and 6.3V DC, 1,000 MΩ or
10MΩ•μF min.,)
*As for the initial measurement of capacitors (Class2) on number 8,12,13,14 and 15, leave capacitor at 150 –10, 0°C for 1
hour and measure the value after leaving capacitor for 24±2h in ambient conditions.
TDK MLCC US Catalog
Page 70
Version B11