CGA5L2X8R1E105KTXXXX Datasheet, PDF (32/36 Pages) TDK Electronics – Automotive Grade Capacitors

General
Specifications
CGA Series – Automotive Grade Capacitors
No. Item
Performance
Test or Inspection Method
16
Life
External
appearance
Capacitance
Q
(Class 1)
No mechanical damage.
Characteristics
Class 1 C0G
Class 2 X7R
X8R
Change from the
value before test
Capacitance drift within
±7.5% or ±0.75pF,
whichever larger.
± 15 %
Rated Capacitance
C ≥ 30pF
10pF ≤ C < 30pF
Q
350 min.
275 + 5/2×C min.
C < 10pF
200 + 10×C min.
C : Rated capacitance (pF)
Reflow solder the capacitor on P.C. board (shown in
Appendix 1a or Appendix 1b) before testing.
Test condition : maximum operating temperature
±2ºC for 1,000 +48,0h.
Please refer to each part number for test voltage.
Charge/discharge current shall not exceed 50mA.
Leave the capacitor in ambient conditions for 6 to 24h
(Class 1) or 24±2h (Class 2) before measurement.
Voltage conditioning:
Voltage treat the capacitors under testing temperature
and voltage for 1 hour.
Leave the capacitor in ambient conditions on for
24±2h before measurement.
Use this measurement for initial value.
D.F.
(Class 2)
Characteristics
X7R: 200% of initial spec. max.
X8R: 200% of initial spec. max
Insulation
Resistance
1,000MΩ or 50MΩ•μF min. , whichever
smaller.
(As for the capacitors of rated voltage
16 DC, 1,000 MΩ or 10MΩ•μF min.,)
*As for the initial measurement of capacitors (Class 2) on number 8, 12, 13 and 14, leave capacitors at 150 –10, 0°C for 1
hour and measure the value after leaving capacitor for 24±2h in ambient conditions.
TDK MLCC US Catalog
Page 320
Version B11