SM8958B Datasheet, PDF (25/49 Pages) SyncMOS Technologies,Inc – 256 bytes SRAM as standard 8052

SM8958B
8-Bit Micro-controller
32KB Flash
& 1KB RAM embedded
6. Timer 0 and Timer 1
The SM8958B has three 16-bit timer/counter registers: Timer 0, Timer 1 and Timer 2. All can be configured for
counter or timer operations.
In timer mode, the Timer 0 register or Timer 1 register is incremented every machine cycles, due to 12 oscillator
periods in a machine cycle, the count rate is 1/12 of the oscillator frequency.
In counter mode, the register is incremented when the falling edge is observed at the corresponding input pin T0 or
T1. Since it takes 2 machine cycles to recognize a 1-to-0 event, the maximum input count rate is 1/2 of the
oscillator frequency. There are no restrictions on the duty cycle, however to ensure proper recognition of 0 or 1
state, an input should be stable for at least 1 machine cycle.
Four operating modes can be selected for Timer 0 and Timer 1. Two Special Function registers (TMOD and TCON)
are used to select the appropriate mode.
Mnemonic
Description
Dir.
TL0
TH0
TL1
TH1
TMOD
TCON
Timer 0 , low byte 8Ah
Timer 0 , high byte 8Ch
Timer 1 , low byte 8Bh
Timer 1 , high byte 8Dh
Timer Mode Control 89h
Timer/Counter
Control
88h
Bit 7 Bit 6 Bit 5
Timer 0 and 1
GATE C/T M1
TF1 TR1 TF0
Bit 4 Bit 3 Bit 2
TL0[7:0]
TH0[7:0]
TL1[7:0]
TH1[7:0]
M0 GATE C/T
TR0 IE1
IT1
Bit 1
M1
IE0
Bit 0
M0
IT0
RST
00H
00H
00H
00H
00H
00H
6.1 Timer/counter mode control register (TMOD)
Mnemonic: TMOD
7
6
5
GATE C/T
M1
Timer 1
Address: 89h
4
3
2
1
0 Reset
M0 GATE C/T
M1
M0 00h
Timer 0
GATE: If set, enables external gate control (pin INT0 or INT1 for Counter 0 or 1,
respectively). When INT0 or INT1 is high, and TRx bit is set (see TCON
register), a counter is incremented every falling edge on T0 or T1 input pin.
C/T: Selects Timer or Counter operation. When set to 1, a counter operation is
performed, when cleared to 0, the corresponding register will function as a
timer.
M1 M0 Mode
Function
0 0 Mode0 13-bit counter/timer, with 5 lower bits in TL0 or
TL1 register and 8 bits in TH0 or TH1 register
(for Timer 0 and Timer 1, respectively). The 3
high order bits of TL0 and TL1 are hold at
zero.
0 1 Mode1 16-bit counter/timer.
1 0 Mode2 8-bit auto-reload counter/timer. The reload
value is kept in TH0 or TH1, while TL0 or TL1
is incremented every machine cycle. When
TLx overflows, a value from THx is copied to
TLx.
Specifications subject to change without notice contact your sales representatives for the most recent information.
ISSFD-M085
Ver D SM8958B 08/07/2015
- 25 -