SMH4814 Datasheet, PDF (1/44 Pages) Summit Microelectronics, Inc. – Dual Feed Active-ORing Programmable Hot Swap Controller

SMH4814
Preliminary Information ¹ (See Last Page)
Dual Feed Active-ORing Programmable Hot Swap Controller
FEATURES AND APPLICATIONS
Eliminates Passive ORing Diodes for Reduced
Power Consumption
High Noise Immunity on All Logic Inputs
Soft Starts Main Power Supply on Card
Insertion or System Power Up with Slew Rate
Control
Programmable Differential Current Sense
• Programmable Inrush Current Limiting
• Master Enable to Allow System Control of
Power-Up or -Down
Programmable Independent Enabling of up to
4 DC/DC Converters
Programmable Circuit Breaker Level and Mode
Programmable Quick-Trip™ Value, Current
Limiting, Duty Cycle Times, Over-Current Filter
Programmable Host Voltage Fault Monitoring
Programmable UV/OV Filter and Hysteresis
Programmable Fault Mode: Latched or Duty
Cycle
Internal Shunt Regulator Allows for a Wide
Supply Range
Applications
Telecom Hot-Swap Card - AdvancedTCA^TM
Network Processors
Power-on Ethernet, IEEE 802.3af
INTRODUCTION
The SMH4814 is an integrated power controller
designed to control the hot-swapping of plug-in cards
in a distributed power environment. The SMH4814
drives external power MOSFET switches that connect
the supply to the load while reducing in-rush current
and providing over-current protection. When the
source and drain voltages of the external MOSFETs
are within specification the SMH4814 asserts the four
PUP logic outputs in a programmable cascade
sequence to enable the DC/DC converters.
The SMH4814 also monitors two independent –48V
feeds. The redundant power supplies allow for high
availability and reliability. The traditional method of
supplying power from these feeds is via ORing power
diodes, which consume a significant amount of power.
The SMH4814 allows low-RDS_ON FETs to be used in
place of ORing diodes to reduce power consumption.
The SMH4814 determines when at least one of the
–48V feeds is within an acceptable voltage range and
switches on the appropriate FET path while providing
slew rate control. The SMH4814 continuously monitors
the incoming feeds and switches to the most negative
feed as necessary. The SMH4814 is programmed and
controlled using the I²C bus as required in ATCA^TM
applications.
SIMPLIFIED APPLICATIONS DRAWING
–48V Ret.
I²C
R_D
Pin
Detect
PD1
UV
OV
SMH4814
VSS
Pin
Detect
R_A
PD0
PUP_A
PUP_B
PUP_C
PUP_D
V_IN+
V_OUT+
DC-to-DC
Converter A
ON/OFF
V_IN-
V_OUT-
A dvanced T C A ^TM
–48V A
–48V B
R_S
R_B
Primary
Secondary
Figure 1. The SMH4814 Controller hot-swaps and cascade sequences up to 4 DC/DC Converters and actively
controls the A and B –48V feeds eliminating the need for ORing diodes and the associated voltage drop.
Note: This is an applications example only. Some pins, components and values are not shown.
© SUMMIT Microelectronics, Inc. 2005 • 1717 Fox Drive • San Jose CA 95131 • Phone [phone] • FAX [phone]
The Summit Web Site can be accessed by “right” or “left” mouse clicking on the link: http://www.summitmicro.com/
2080 2.0 07/21/05
1