LPS25H Datasheet, PDF (30/45 Pages) STMicroelectronics – Embedded temperature compensation

Register description
LPS25H
7.10 INTERRUPT_CFG
7
6
5
4
RESERVED
Interrupt configuration
3
2
1
0
LIR
PL_E
PH_E
Address:
Reset:
Description:
24h (R/W)
00h
Interrupt differential configuration register. See DIFF_EN bit in CTRL_REG1
[7:3] RESERVED
[2] LIR: Latch Interrupt request into INT_SOURCE register. Default value: 0.
(0: interrupt request not latched; 1: interrupt request latched)
[1] PL_E: Enable interrupt generation on differential pressure low event. Default value: 0.
(0: disable interrupt request;
1: enable interrupt request on measured differential pressure value lower than preset threshold)
[0] PH_E: Enable interrupt generation on differential pressure high event. Default value: 0
(0: disable interrupt request;
1:enable interrupt request on measured differential pressure value higher than preset
threshold)
30/45
DocID023722 Rev 5