LCD-14048 Datasheet, PDF (5/33 Pages) SparkFun Electronics – TeensyView Hookup Guide

Page 5 of 33
Attaching the Teensy Header Kit
6. If you’ve decided to only solder the electrically connected pins, now’s
a good time to pull the spare pins. Hold the TeensyView firmly with
one hand and give a steady pull with pliers or wire strippers. To
double check, there should only be pins left in the holes with
silkscreen rings.
Pulling the pins
7. Apply the screen using the double-sided foam. It’s best to start with
little pieces until you’re sure of the configuration you would like.
Visualize how the foam will be divided or draw on it with a pen. Then
use your scissors to cut off strips, and subdivide from there.
A way to divide the square of foam tape
A couple small pieces go a long way to keep it in place, while a large
piece can keep it there on a more permanent basis. Reasons to
remove the screen may be to adjust left-right justification (to match a
chassis cutout, for example) or to change the configuration of the
pins. It can be tempting to just start with a large piece, but don’t! The
foam is extremely grippy once it’s set.