LCD-14048 Datasheet, PDF (28/33 Pages) SparkFun Electronics – TeensyView Hookup Guide

// clear(ALL) will clear out the OLED's graphic memory.
// clear(PAGE) will clear the Arduino's display buffer.
oled.clear(ALL); // Clear the display's memory (gets rid o
f artifacts)
// To actually draw anything on the display, you must call t
he
// display() function.
oled.display();
delay(2000);
oled.clear(PAGE);
oled.setCursor(0, 0);
oled.print("Heading");
oled.setCursor(50, 0);
oled.print("Pitch");
oled.setCursor(90, 0);
oled.print("Roll");
oled.line(0, 9, 127, 9);
oled.display();
//********************Audio test*******************//
AudioMemory(40);
mixer1.gain(0, 0.1);
mixer1.gain(1, 0.1);
mixer1.gain(2, 0.1);
mixer1.gain(3, 0.1);
filter1.frequency(500);
filter1.octaveControl(2);
filter1.resonance(2);
filter2.frequency(500);
filter1.octaveControl(2);
filter2.resonance(2);
dc1.amplitude(0);
setSines(110);
pinMode(5, OUTPUT);
digitalWrite(5, HIGH); // turn on the amplifier
delay(10);
//********************Audio test*******************//
Serial.begin(9600);
//********************IMU test*******************//
imu.begin();
filter.begin(100);
//********************IMU test*******************//
//********************RAW APA102*******************//
pinMode(7, OUTPUT); //Configure chip select pin
//********************RAW APA102*******************//
//********************Flash Test*******************//
if (!SerialFlash.begin(FlashChipSelect)) {
Serial.println("Unable to access SPI Flash chip");
}
uint8_t id[5];
SerialFlash.readID(id);
Serial.println("ID word:");
Serial.print("0x");
Serial.println(id[0], HEX);
Serial.print("0x");
Serial.println(id[1], HEX);
Serial.print("0x");
Serial.println(id[2], HEX);
Serial.print("0x");
Serial.println(id[3], HEX);
Page 28 of 33