SKY85806-11 Datasheet, PDF (8/17 Pages) Skyworks Solutions Inc. – Dual-Band 802.11a-g-n-ac Wireless LAN

DATA SHEET • SKY85806-11: DUAL-BAND 802.11a/g/n/ac WIRELESS LAN FRONT END
Table 10. SKY85806-11 Electrical Specifications: Special States (Note 1)
Special State
Test Condition
Bluetooth ready
All other control pins = VCTL_OFF
Note 1: Performance is guaranteed only under the conditions listed in this table.
Control Logic
VCC = 0 V; CBT = VCTL_ON
Table 11. SKY85806-11 Electrical Specifications: Low-Band Bluetooth Path Specifications (Note 1)
(Vcc = 3.3 V, Control States 11 through 19 and Bluetooth Ready, Ta = 25 C as Measured on the Evaluation Board, All Unused Ports are
Terminated with 50 Ω, Unless Otherwise Noted)
Parameter
Symbol
Test Condition
Minimum Typical Maximum
Units
Loss:
Input return
Output return
Insertion
Insertion variation
S11
At ANT port
S22
At BT port
S21
ANT port to BT port
∆S21
Over entire frequency range
–10
dB
–10
dB
–1.7
dB
–0.2
+0.2
dB
Bluetooth high-band gain
S21HB
ANT port to BT port gain,
measured at 5.1 to 5.9 GHz
–15
dB
Bluetooth to non-RF pin isolation
LBTbcd
External bypass capacitor required on the BT control
line (see the schematic)
+40
dB
Input:
1dB Input Compression Point IP1dB
3^rd Order Input Intercept Point IIP3
+24
dBm
+35
dBm
2nd and 3rd harmonic power
spectral density (PSD):
HD2
HD3
POUT = +18 dBm
POUT = +18 dBm
–55
dBm/MHz
–55
dBm/MHz
Note 1: Performance is guaranteed only under the conditions listed in this table.
Table 12. SKY85806-11 Electrical Specifications: Power Detector Characteristics (Note 1)
(Vcc = 3.3 V, Control State 4, Ta = 25 C as Measured on the Evaluation Board, All Unused Ports are Terminated with 50 Ω,
Unless Otherwise Noted)
Parameter
Symbol
Test Condition
Minimum Typical Maximum
Frequency range
fOUT
2400
2500
Power detect range, peak power
PDR
Measured at ANT
0
+22
DC output impedance
PDZOUT
4
Output voltage:
+21 dBm
No RF
PDVP21
PDVpnoRF
POUT = +21 dBm
POUT = No RF
820
900
950
125
225
Power detect low pass filter, +3 dB corner frequency LPF–3dB
Measured at POUT = 18 dBm
900
Power detector accuracy
Pdetacc
Measured into 2:1 load at ANT port
–1.5
+1.5
Power detector:
Operating voltage
Maximum limit
Sensitivity
VPDOP
0 dBm to +22 dBm
200
975
VPDLIM
Maximum PDET voltage
1.2
VPDSENS
0 dBm to +22 dBm
+10
+100
Note 1: Performance is guaranteed only under the conditions listed in this table.
Units
MHz
dBm
kΩ
mV
mV
kHz
dB
mV
V
mV/dB
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [e-mail] • www.skyworksinc.com
8
February 6, 2015 • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice • 203186E