SKY85806-11 Datasheet, PDF (7/17 Pages) Skyworks Solutions Inc. – Dual-Band 802.11a-g-n-ac Wireless LAN

DATA SHEET • SKY85806-11: DUAL-BAND 802.11a/g/n/ac WIRELESS LAN FRONT END
Table 8. SKY85806-11 Electrical Specifications: AC Characteristics: 5 GHz Receive Characteristics (Note 1)
(VCC = 3.3 V, Control States 6 or 15, TA = 25 C as Measured on the Evaluation Board, All Unused Ports are Terminated with 50 Ω,
Unless Otherwise Noted)
Parameter
Symbol
Test Condition
Minimum Typical Maximum Units
Frequency range
fOUT
5150
5900
MHz
Receive gain:
LNA enabled
Bypass mode
S21
5150 MHz to 5900 MHz, control state 6 or 15
LNA bypassed:
Control state 7 or 16
Control state 8 or 17
+9.5
+11
+12.5
dB
–6.2
–6
–4.7
dB
–9.2
–9
–7.7
dB
Gain step
ANT  RXa isolation
BT  RXa isolation
Gain variation
GSg
LTXRXa
LBTRXa
∆S21
LNA gain vs LNA bypass, from control state 6 or 15 to
control state 8 or 17
Control states 9, 10, 18, and 19
Control states 9, 10, 18, and 19
Over any 80 MHz band
Over the entire range
19
20
21
dB
+37
dB
+37
dB
–0.5
+0.5
dB
–1.3
+1.3
dB
Noise figure
NF
Control state 6 or 15
+3.6
+3.8
dB
Return loss:
Input
Output
S11
At antenna port for all 5 GHz receive gain states
S22
At RXa port for all 5 GHz receive gain states
–6
dB
–14
–10
dB
Input:
1 dB Input Compression Point
IP1dB
3rd Order Input Intercept Point IIP3
Control state 6 or 15
Control state 7, 8, 16, or 17
Control state 6 or 15
Control state 7, 8, 16, or 17
–4
dBm
+13
dBm
+3
dBm
+23
dBm
Rx gain switching
tEN
50% edge of the P0/P1 signal to 90%/10% of final output
power at the RXa port:
State 6 (or 15) to state 7 (or 16) and 8 (or 17)
State 7 (or 16) to state 6 (or 15) and 8 (or 17)
State 8 (or 18) to state 6 (or 15) and 7 (or 16)
160
250
ns
160
250
ns
160
250
ns
Low band gain
S21_OOB
2400 MHz to 2500 MHz, control states 6, 7, 8, 15, 16, or 17
–40
–37
dB
Note 1: Performance is guaranteed only under the conditions listed in this table.
Table 9. SKY85806-11 Electrical Specifications: Logic Characteristics (Note 1)
(VCC = VEN = 3.3 V, TA = 25 C as Measured on the Evaluation Board, All Unused Ports are Terminated with 50 Ω, Unless Otherwise Noted)
Parameter
Symbol
Test Condition
Minimum
Typical
Maximum
Units
Control voltage:
On state (Bluetooth only)
On state (all other controls)
Off state (all controls)
VCBT_ON
VCTL_ON
VCTL_OFF
3.0
3.3
3.6
V
3.0
3.6
V
0
0.2
V
Loss switch control:
Low
High
SWON
High state = VCTL_ON to VCTL_OFF
1.8
SWOFF
Low state = VCTL_OFF to VCTL_OFF
0
VCC
V
0.3
V
Bias current, each control line
ICTL_ON
No unused pull-up/down resistors
(excludes CBT pin when CBT = 3.3 V
and VDD = 0.0 V)
1
μA
Control input capacitance
CCTL
0.500
pF
Note 1: Performance is guaranteed only under the conditions listed in this table.
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [e-mail] • www.skyworksinc.com
203186E • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice • February 6, 2015
7