SI4460-C2A-GM Datasheet, PDF (6/53 Pages) Silicon Laboratories – HIGH-PERFORMANCE, LOW-CURRENT TRANSCEIVER

Si4463/61/60-C
Table 3. Receiver AC Electrical Characteristics^1,2
Parameter
RX Frequency Range
RX Sensitivity 169 MHz³
Symbol
Test Condition
Min
F_RX
850
350
284
142
P_{RX_0.5}
(BER < 0.1%)
—
(500 bps, GFSK, BT = 0.5,
f = 250Hz)
P_{RX_40}
(BER < 0.1%)
—
(40 kbps, GFSK, BT = 0.5,
f = 20 kHz)
P_{RX_100}
(BER < 0.1%)
—
(100 kbps, GFSK, BT = 0.5,
f = 50 kHz)
P_{RX_500}
(BER < 0.1%)
—
(500 kbps, GFSK, BT = 0.5,
f = 250 kHz)
P_{RX_9.6}
(PER 1%)
—
(9.6 kbps, 4GFSK, BT = 0.5,
f = ±2.4 kHz)
P_{RX_1M}
(PER 1%)
—
(1 Mbps, 4GFSK, BT = 0.5,
inner deviation = 83.3 kHz)
P_{RX_OOK} (BER < 0.1%, 4.8 kbps, 350 kHz BW, —
OOK, PN15 data)
(BER < 0.1%, 40 kbps, 350 kHz BW, —
OOK, PN15 data)
(BER < 0.1%, 120 kbps, 350 kHz BW, —
OOK, PN15 data)
Typ
—
—
—
—
–129
Max
1050
525
350
175
—
Unit
MHz
MHz
MHz
MHz
dBm
–110 –108 dBm
–106 –104 dBm
–98 –96 dBm
–110 — dBm
–89 — dBm
–110 –107 dBm
–103 –100 dBm
–97 –93 dBm
Notes:
1. All minimum and maximum values are guaranteed across the recommended operating conditions of supply voltage and
from –40 to +85 °C unless otherwise stated. All typical values apply at VDD = 3.3 V and 25 °C unless otherwise stated.
2. For PER tests, 48 preamble symbols, 4 byte sync word, 10 byte payload and CRC-32 was used.
3. Measured over 50000 bits using PN9 data sequence and data and clock on GPIOs. Sensitivity is expected to be better
if reading data from packet handler FIFO especially at higher data rates.
6
Rev 1.0