EFM8BB3 Datasheet, PDF (10/70 Pages) Silicon Laboratories – The EFM8BB3 device family are fully integrated, mixed-signal system-on-a-chip MCUs. Highlighted features are listed below

EFM8BB3 Data Sheet
System Overview
I2C Slave (I2CSLAVE0)
The I2C Slave interface is a 2-wire, bidirectional serial bus that is compatible with the I2C Bus Specification 3.0. It is capable of transfer-
ring in high-speed mode (HS-mode) at speeds of up to 3.4 Mbps. Firmware can write to the I2C interface, and the I2C interface can
autonomously control the serial transfer of data. The interface also supports clock stretching for cases where the core may be tempora-
rily prohibited from transmitting a byte or processing a received byte during an I2C transaction. This module operates only as an I2C
slave device.
The I2C module includes the following features:
• Standard (up to 100 kbps), Fast (400 kbps), Fast Plus (1 Mbps), and High-speed (3.4 Mbps) transfer speeds
• Support for slave mode only
• Clock low extending (clock stretching) to interface with faster masters
• Hardware support for 7-bit slave address recognition
• Hardware support for multiple slave addresses with the option to save the matching address in the receive FIFO
16-bit CRC (CRC0)
The cyclic redundancy check (CRC) module performs a CRC using a 16-bit polynomial. CRC0 accepts a stream of 8-bit data and posts
the 16-bit result to an internal register. In addition to using the CRC block for data manipulation, hardware can automatically CRC the
flash contents of the device.
The CRC module is designed to provide hardware calculations for flash memory verification and communications protocols. The CRC
module supports the standard CCITT-16 16-bit polynomial (0x1021), and includes the following features:
• Support for CCITT-16 polynomial
• Byte-level bit reversal
• Automatic CRC of flash contents on one or more 256-byte blocks
• Initial seed selection of 0x0000 or 0xFFFF
Configurable Logic Units (CLU0, CLU1, CLU2, and CLU3)
The Configurable Logic block consists of multiple Configurable Logic Units (CLUs). CLUs are flexible logic functions which may be used
for a variety of digital functions, such as replacing system glue logic, aiding in the generation of special waveforms, or synchronizing
system event triggers.
• Four configurable logic units (CLUs), with direct-pin and internal logic connections
• Each unit supports 256 different combinatorial logic functions (AND, OR, XOR, muxing, etc.) and includes a clocked flip-flop for syn-
chronous operations
• Units may be operated synchronously or asynchronously
• May be cascaded together to perform more complicated logic functions
• Can operate in conjunction with serial peripherals such as UART and SPI or timing peripherals such as timers and PCA channels
• Can be used to synchronize and trigger multiple on-chip resources (ADC, DAC, Timers, etc.)
• Asynchronous output may be used to wake from low-power states
silabs.com | Smart. Connected. Energy-friendly.
Preliminary Rev. 0.2 | 9