SI7013-A20 Datasheet, PDF (1/45 Pages) Silicon Laboratories – IC HUMIDITY AND TWO-ZONE TEMPERATURE SENSOR

Si7013-A20
I²C HUMIDITY AND TWO-ZONE TEMPERATURE SENSOR
Features
 Precision Relative Humidity Sensor  Factory-calibrated
 ± 3% RH (max), 0–80% RH
 I²C Interface
 High Accuracy Temperature Sensor _{ Integrated on-chip heater}
±0.4 °C (max), –10 to 85 °C
 Auxiliary Sensor input
 0 to 100% RH operating range
Direct readout of remote
 Up to –40 to +125 °C operating
thermistor temperature in °C
range
 Package: 3x3 mm DFN
 Low Voltage Operation (1.9 to 3.6 V) _{ Excellent long term stability}
 Low Power Consumption
 Optional factory-installed cover
150 μA active current
Low-profile
60 nA standby current
Protection during reflow
Excludes liquids and particulates
Applications
 HVAC/R
 Thermostats/humidistats
 Instrumentation
 White goods
 Micro-environments/data centers
 Industrial Controls
 Indoor weather stations
Ordering Information:
See page 38.
Pin Assignments
Top View
Description
The Si7013 I²C Humidity and 2-Zone Temperature Sensor is a monolithic CMOS
IC integrating humidity and temperature sensor elements, an analog-to-digital
converter, signal processing, calibration data, and an I²C Interface. The patented
use of industry-standard, low-K polymeric dielectrics for sensing humidity enables
the construction of low-power, monolithic CMOS Sensor ICs with low drift and
hysteresis, and excellent long term stability.
The humidity and temperature sensors are factory-calibrated and the calibration
data is stored in the on-chip non-volatile memory. This ensures that the sensors
are fully interchangeable, with no recalibration or software changes required.
An auxiliary sensor input with power management can be tied directly to an
external thermistor network or other voltage-output sensor. On-board logic
performs calibration/linearization of the external input using user-programmable
coefficients. The least-significant bit of the Si7013's I²C address is programmable,
allowing two devices to share the same bus.
The Si7013 is available in a 3x3 mm DFN package and is reflow solderable. The
optional factory-installed cover offers a low profile, convenient means of
protecting the sensor during assembly (e.g., reflow soldering) and throughout the
life of the product, excluding liquids (hydrophobic/oleophobic) and particulates.
The Si7013 offers an accurate, low-power, factory-calibrated digital solution ideal
for measuring humidity, dew-point, and temperature, in applications ranging from
HVAC/R and asset tracking to industrial and consumer platforms.
Patent Protected. Patents pending
Rev. 1.1 6/15
Copyright © 2015 by Silicon Laboratories
Si7013-A20