S-8215AAA-K8T2U Datasheet, PDF (18/29 Pages) Seiko Instruments Inc – BATTERY PROTECTION IC FOR 3-SERIAL TO 5-SERIAL CELL PACK

BATTERY PROTECTION IC FOR 3-SERIAL TO 5-SERIAL CELL PACK (SECONDARY PROTECTION)
S-8215A Series
Rev.2.3_02
[For SC PROTECTOR, contact]
Device Sales Dept., Advanced Process Device Division, Dexerials Corporation
Gate City Osaki East Tower 8F, 1-11-2
Osaki, Shinagawa-ku, Tokyo, 141-0032 Japan
TEL [phone]
Contact Us: http://www.dexerials.jp/en/
 Precautions
• Do not connect batteries charged with V_CUn + V_HCn or higher. If the connected batteries include a battery charged with
V_CUn + V_HCn or higher, the S-8215A series may become overcharge status after all pins are connected.
• In some application circuits, even if an overcharged battery is not included, the order of connecting batteries may be
restricted to prevent transient output of CO detection pulses when the batteries are connected. Perform thorough
evaluation with the actual application circuit.
• Before the battery connection, short-circuit the battery side pins R_VDD and R1, shown in the figure in " Battery
Protection IC Connection Examples".
• The application conditions for the input voltage, output voltage, and load current should not exceed the package power
dissipation.
• Do not apply to this IC an electrostatic discharge that exceeds the performance ratings of the built-in electrostatic
protection circuit.
• SII Semiconductor Corporation claims no responsibility for any disputes arising out of or in connection with any
infringement of patents owned by a third party by products including this IC.
18