S-8211DAD-M5T1X Datasheet, PDF (14/38 Pages) Seiko Instruments Inc – BATTERY PROTECTION IC

BATTERY PROTECTION IC FOR 1-CELL PACK
S-8211D Series
Rev.6.5_02
16. Discharge overcurrent detection delay time
(Test condition 9, test circuit 5)
Discharge overcurrent detection delay time (tDIOV) is the time needed for VDO to go to "L" after the voltage V2
momentarily increases (within 10 μs) from 0 V to 0.35 V under the set conditions of V1 = 3.5 V, V2 = 0 V.
17. Load short-circuiting detection delay time
(Test condition 9, test circuit 5)
Load short-circuiting detection delay time (tSHORT) is the time needed for VDO to go to "L" after the voltage V2
momentarily increases (within 10 μs) from 0 V to 1.6 V under the set conditions of V1 = 3.5 V, V2 = 0 V.
18. 0 V battery charge starting charger voltage (0 V battery charge function "available")
(Test condition 10, test circuit 2)
The 0 V battery charge starting charger voltage (V0CHA) is defined as the voltage between the VDD pin and the VM
pin at which VCO goes to "H" (VVM + 0.1 V or higher) when the voltage V2 is gradually decreased from the starting
condition of V1 = V2 = 0 V.
19. 0 V battery charge inhibition battery voltage (0 V battery charge function "unavailable")
(Test condition 11, test circuit 2)
The 0 V battery charge inhibition battery voltage (V0INH) is defined as the voltage between the VDD pin and the VSS
pin at which VCO goes to "H" (VVM + 0.1 V or higher) when the voltage V1 is gradually increased from the starting
condition of V1 = 0 V, V2 = −4 V.
14