HYS64V8000GU Datasheet, PDF (9/11 Pages) Siemens Semiconductor Group – 3.3V 8M x 64-Bit SDRAM Module 3.3V 8M x 72-Bit SDRAM Module

HYS64(72)V8000GU-10
8M x 64/72 SDRAM-Module
Notes:
1. The specified values are valid when addresses are changed no more than once during tck(min.)
and when No Operation commands are registered on every rising clock edge during tRC(min).
2. The specified values are valid when data inputs (DQs’ ) are stable during tRC(min.).
3. An initial pause of 100µs is required after power-up, then a Precharge All Banks command must
be given followed by 8 Auto Refresh (CBR) cycles before the Mode Register Set Operation can
begin.
4. AC timing tests have V_il = 0.4 V and V_ih = 2.4 V with the timing referenced to the 1.4 V crossover
point. The transition time is measured between V _ih and V_il. All AC measurements assume t _T=1ns
with the AC output load circuit shown.
tCH
CLOCK
tCL
tSETUP tHOLD
2.4 V
0.4 V
t_T
+ 1.4 V
INPUT
1.4V
Z=50 Ohm
50 Ohm
I/O
tAC
tAC
tLZ
tOH
50 pF
OUTPUT
1.4V
fig.1
tHZ
5. If clock rising time is longer than 1 ns, a time (t _T/2 -0.5) ns has to be added to this parameter.
6. If t_T is longer than 1 ns, a time (t _T -1) ns has to be added to this parameter.
7. Any time that the refresh Period has been exceeded, a minimum of two Auto (CBR) Refresh
commands must be given to “wake-up“the device.
8. Self Refresh Exit is a synchronous operation and begins on the 2nd positive clock edge after
CKE returns high. Self Refresh Exit is not complete until a time period equal to tRC is satisfied
once the Self Refresh Exit command is registered.
9. Referenced to the time which the output achieves the open circuit condition, not to output voltage
levels.
Semiconductor Group
9