SKYPER42R Datasheet, PDF (5/18 Pages) Semikron International – IGBT Driver Core

SKYPER^® 42 R
For integrating the SKYPER 42 R driver core in to an inverter system an adaptor board has to be built.
SEMIKRON offers a wide range of adaptor boards, e.g. for SEMiX, Semitrans or SKiM modules.
SEMIKRON offers in addition a customer specific adaptor board on demand. Please contact your
responsible sales for further information.
Adaptor boards for SKYPER 42 R
SKYPER 42 R can be plugged or soldered on the adaptor board.
Soldering Hints
The temperature of the solder must not exceed 260°C, and solder time must not exceed 10 seconds.
The ambient temperature must not exceed the specified maximum storage temperature of the driver.
The solder joints should be in accordance to IPC A 610 Revision D (or later) - Class 3 (Acceptability of Electronic Assemblies) to
ensure an optimal connection between driver core and printed circuit board.
The driver is not suited for hot air reflow or infrared reflow processes.
Use of Support Posts
The connection between driver core and printed circuit
board should be mechanical reinforced by using support
posts.
The driver board has got three holes for supports posts.
Using support posts with external screw thread improves
mechanical assembly.
Product information of suitable support posts and
distributor contact information is available at e.g.
http://www.richco-inc.com or http://www.ettinger.de.
4
2011-04-04 – Rev05
© by SEMIKRON