SKYPER32PROR_0701 Datasheet, PDF (5/18 Pages) Semikron International – IGBT Driver Core

SKYPER™ 32PRO R
PIN Array – Primary Side
Connectors
Connector X10 / X11 (RM2,54, 10pin)
SQ 0,64
2,54
±0,25mm unless otherwise noted
PIN
X10:01
X10:02
X10:03
X10:04
X10:05
X10:06
X10:07
X10:08
X10:09
X10:10
X11:01
X11:02
X11:03
X11:04
X11:05
X11:06
X11:07
X11:08
X11:09
X11:10
Signal
PRIM_nPWRFAIL_IN
reserved
PRIM_HALT_OUT
PRIM_HALT_IN
PRIM_PWR_GND
PRIM_PWR_GND
PRIM_TOP_IN
PRIM_BOT_IN
PRIM_PWR_15P
PRIM_PWR_15P
reserved
reserved
PRIM_PWR_GND
PRIM_PWR_GND
PRIM_CFG_TDT2_IN
PRIM_CFG_SELECT_IN
PRIM_CFG_TDT3_IN
PRIM_CFG_TDT1_IN
PRIM_PWR_GND
PRIM_PWR_GND
Function
Under Voltage Reset (supervisor reset to be
driven by an external circuitry)
Specification
Inverted 15 V logic; 100kOhm impedance;
LOW = hold;
HIGH = normal operation
Driver core status output
Driver core status input
GND for power supply and GND for digital
signals
GND for power supply and GND for digital
signals
Switching signal input (TOP switch)
Switching signal input (BOTTOM switch)
Drive core power supply
Drive core power supply
Digital 15 V logic; max. 2mA;
LOW = ready to operate;
HIGH = not ready to operate
Digital 15 V logic; 100kOhm impedance;
LOW = enable driver;
HIGH = disable driver
Digital 15 V logic; 100kOhm impedance;
LOW = TOP switch off;
HIGH = TOP switch on
Digital 15 V logic; 100kOhm impedance;
LOW = BOT switch off;
HIGH = BOT switch on
Stabilised +15V ±4%
Stabilised +15V ±4%
GND for power supply and GND for digital
signals
GND for power supply and GND for digital
signals
Digital adjustment of locking time
Signal for neutralizing locking function
Digital adjustment of locking time
Digital adjustment of locking time
GND for power supply and GND for digital
signals
GND for power supply and GND for digital
signals
Dead time bit #2
Dead time bit #3
Dead time bit #1
5
2007-01-19 – Rev03
© by SEMIKRON