LC87F2708A Datasheet, PDF (4/21 Pages) Sanyo Semicon Device – CMOS IC FROM 8K byte, RAM 512 byte on-chip 8-bit 1-chip Microcontroller

LC87F2708A
„Standby Function
• HALT mode: Halts instruction execution while allowing the peripheral circuits to continue operation.
1) Oscillation is not halted automatically.
2) There are the following three ways of resetting the HALT mode.
(1) Setting the reset pin to the low level
(2) Generating a reset signal via the watchdog timer or brown-out detector
(3) Having an interrupt generated
• HOLD mode: Suspends instruction execution and the operation of the peripheral circuits.
1) The medium- and high-speed RC oscillation circuits automatically stop operation.
2) There are the following four ways of resetting the HOLD mode.
(1) Setting the reset pin to the lower level.
(2) Generating a reset signal via the watchdog timer or brown-out detector
(3) Setting at least one of the INTA, INTB, INTC, INTD, INTE, and INTF pins to the specified level
(4) Applying input signals to the IN+ and IN- pins so that the analog comparator output is set to the specified
level (when the analog comparator output is assigned to the INTC input)
„On-chip Debugger Function
• Supports software debugging with the IC mounted on the target board.
• 3 channels of on-chip debugger pins are available.
„Data Security Function ^Note3
• Protects the program data stored in flash memory from unauthorized read or copy.
Note3: This data security function does not necessarily provide absolute data security.
„Package Form
• MFP14S(225mil): Lead-free Type
„Development Tools
• On-chip debugger: TCB87 Type B + LC87F2708A
„Flash ROM Programming Board
Maker
SANYO
Note4: Check for the latest version.
Model
SKK-DBG Type B
(SANYO FWS)
Version ^Note4
Application Version
1.04 or later
Chip Data Version
2.10 or later
Device
LC87F2708A
No.A1335-4/21