BU94601KV_12 Datasheet, PDF (52/70 Pages) Rohm – AAC/WMA/MP3 +SD Memory Card + iPod

BU94601KV BU94603KV BU94604BKV
Datasheet
SET_
RESUME_
INFO7
SET_
RESUME_
INFO8
SET_EQ
*See Chapter
22.3.
SET_VOL
FFP_ON
FFP_OFF
FBP_ON
FBP_OFF
SEL_12MOUT
SET_DIRECT
SET_WDT
· This command sets byte 37 to 42 of 42-byte data obtained
RESUME
0x47 INFO
by “READ_RESUME_INFO”. When RESUME reproduction
is possible, play started that music. When RESUME is
impossible, play the head music of media is started.
37byte-42byte _{· About some kind of setting of Resume Play, see Application}
Note.
· This command sets byte 37 to 42 of 42-byte data obtained
RESUME
0x48 INFO
by “READ_RESUME_INFO”. When RESUME reproduction
is possible, it stops in the music. When RESUME is
impossible, it stops at the head of media.
37byte-42byte _{· About some kind of setting of Resume Play, see Application}
Note.
0x00
-
· This command turns OFF EQ setting.
0x01
-
· POPS
0x02
-
· JAZZ
0x03
-
· ROCK
0x04
-
· CLASSIC
0x05
-
· R&B
0x07
-
· This command turns OFF EQ setting.
0x52
0x08
-
· BASS BOOST
2
0x09
-
· POPS+BASS
0x0A
-
· JAZZ+BASS
0x0B
-
· ROCK+BASS
0x0C
-
· CLASSIC+BASS
0x0D
-
· R&B+BASS
0x0F
-
· BASS BOOST2
0x53 ^Setting
-
value
· Set sound volume the second byte value of the command.
The setting values are 32 steps ranging from 0x00 to 0x1F.
· A value specified outside the above range will be ignored.
. Start the fast-forwarding playback from a present playback
0x02 0x00 position by this command of playbacking and pausing.
0x01
. Stop the fast-forwarding playback by this command
0x03 0x00 fast-forwarding playback, and usually playback.
4 0x55
. Start the rewinding playback from a present playback
0x02 0x00 position by this command of playbacking and pausing.
0x02
. Stop the rewinding playback by this command rewinding
0x03 0x00 playback, and usually playback.
0x00
-
· This command stops 12 MHz clock output from CLKOUT12
terminal.
2 0x58
· This command enables 12 MHz clock output from
0x01
-
CLKOUT12 terminal.
· This command specifies the current position of the
folder/file by specifying the folder/file information access
8 0x59 0x00 0xXX
data (6 bytes).
· Specify access data (6 bytes) at 0xXX.
· By specifying “0”, the position is set to the root folder.
0x00
-
· This command stops Watch Dog Timer.
2 0x5A
0x01
-
· This command writes “1” to STATUS WDT_RFLG.
www.rohm.com
© 2012 ROHM Co., Ltd. All rights reserved.
TSZ22111・15・001
52/66
TSZ02201-0V2V0E600010-1-2
2012.07.12 Rev.001