|
BU9829GUL-W_10 Datasheet, PDF (1/17 Pages) Rohm – WL-CSP EEPROM family SPI BUS | |||
|
High Reliability Serial EEPROMs
WL-CSP EEPROM family
SPI BUS
BU9829GUL-W
âDescription
BU9829GUL-W is Serial EEPROM built-in LDO regulator by SPI BUS interface.
âFeatures
âEEPROM PART
1) 2,048 wordsÃ8 bits architecture serial EEPROM
2) Wide operating voltage range (1.6Vï½3.6V)
3) Serial Peripheral Interface
4) Self-timed write cycle with automatic erase
5) Low Power consumption
Write
(3.6V) : 1.5mA (Typ.)
Read (3.6V) : 0.5mA (Typ.)
Standby (3.6V) : 0.1µA (Typ.)
6) Auto-increment of registers address for Read mode
7) 32 byte Page Write mode
8) DATA security
Defaults to power up with write-disabled state
Software instructions for write-enable/disable
Block writes protection by status register
Write inhibit at low Vcc
9) Initial data FFh in all address, 00h in status register and 10 in VSET[1:0].
10) Data retention: 10 years
11) Endurance : 100,000 erase/write cycles
âLDO REGULATOR PART
12) Low power consumption
Standby (3.6V) : 0.1 µA (Typ.)
Operation (3.6V) : 0.1mA (Typ.)
13) Power on/off by enable pin
14) Initial LDO output voltage 2.9V
15) Setting output voltage by EEPROM command (VSET WRITE)
âAbsolute maximum rating (Ta=25â)
Parameter
Symbol
Rating
Unit
Supply Voltage
Vcc1(EEPROM)
Vcc2(LDO)
-0.3ï½4.5
V
Power Dissipation
Pd
220
mW
Storage Temperature
Tstg
-65 ï½ 125
â
Operating Temperature
Topr
-30 ï½ 85
â
Terminal Voltage
ï¼
-0.3ï½Vccï¼0.3
V
âEEPROM recommended operating condition
Parameter
Symbol
Supply Voltage
Vcc1
Input Voltage
VIN
Rating
Unit
1.6ï½3.6
0ï½Vcc1
V
âLDO regulator recommended operating condition
Parameter
Symbol
Supply Voltage
Vcc2
Input Voltage
VIN
Rating
Unit
2.9ï½3.6
V
0ï½Vcc2
www.rohm.com
© 2010 ROHM Co., Ltd. All rights reserved.
1/16
No.10001EAT13
2010.09 - Rev.A
|
▷ |