H8S2339 Datasheet, PDF (91/1244 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2300 Series

Section 2 CPU
End of bus request
Bus request
End of bus
request
Bus-released state
End of
exception
handling
Program execution
state
Bus
request
SLEEP
instruction
with
SLEEP _{SSBY = 0}
instruction
with
SSBY = 1
Request for
exception
handling
Sleep mode
Exception-handling state
Interrupt
request
External interrupt
Software standby mode
RES = high
Reset state^*1
STBY = high, RES = low
Hardware standby mode^*2
Power-down state
Notes: 1. From any state except hardware standby mode, a transition to the reset state occurs whenever RES
goes low. A transition can also be made to the reset state when the watchdog timer overflows.
2. From any state, a transition to hardware standby mode occurs when STBY goes low.
Figure 2.12 State Transitions
2.8.2 Reset State
When the RES input goes low all current processing stops and the CPU enters the reset state. All
interrupts are masked in the reset state. Reset exception handling starts when the RES signal
changes from low to high.
The reset state can also be entered by a watchdog timer overflow. For details, refer to section 13,
Watchdog Timer.
Rev.4.00 Sep. 07, 2007 Page 61 of 1210
REJ09B0245-0400