PD178016GC-051_15 Datasheet, PDF (87/96 Pages) Renesas Technology Corp – 8-BIT SINGLE-CHIP MICROCONTROLLER WITH BUILT-IN PRESCALER, PLL FREQUENCY SYNTHESIZER, AND IF COUNTER FOR AUTOMOTIVE FM/MW/LW RADIO APPLICATIONS

µPD178016GC-051
DC CHARACTERISTICS (TA = -40 to +85 °C, VDD = 3.5 to 5.5 V)
(3/3)
Parameter
Supply current^{Note 1}
Symbol
Conditions
MIN. TYP. MAX. Unit
IDD1
While the CPU is
TCY = 0.89 µs^{Note 2}
operating but the PLL is
IDD2
TCY = 0.44 µs^{Note 3}
halted
VDD = 4.5 to 5.5 V
At fX = 4.5 MHz
2.5
15
mA
4.0
27
mA
IDD3
While the CPU is
TCY = 0.89 µs^{Note 2}
IDD4
operating but the PLL is
TCY = 0.44 µs^{Note 3}
halted
VDD = 4.5 to 5.5 V
HALT mode
A sinusoidal wave is
applied to the X1 pin (VIN
= VDD).
At fX = 4.5 MHz
0.7
1.5
mA
1.0
2.0
mA
Data hold supply voltage VDDR1
While the crystal oscillator TCY = 0.44 µs
4.5
VDDR2
is operating
TCY = 0.89 µs
3.5
VDDR3
While the crystal oscillator
2.6
is halted
When the power failure is
detected by power-on
clear
5.5
V
5.5
V
5.5
V
Data hold supply current IDDR1
While the crystal oscillator TA = 25 °C
is halted
VDD = 5 V
2
4
µA
IDDR2
2
30
µA
Notes 1. The port current is not included.
2. When both the processor clock control register (PCC) and the oscillation mode selection register
(OSMS) are set to 00H
3. When the PCC is set to 00H, and the OSMS is set to 01H
Remarks 1. TCY: Cycle time (minimum instruction execution time)
2. fX: System clock oscillator frequency
REFERENCE CHARACTERISTICS (TA = 25 °C, VDD = 5 V)
(2/2)
Parameter
Supply current
Symbol
Conditions
MIN. TYP. MAX. Unit
IDD5
While the CPU and PLL are TCY = 0.44 µs^Note
7
mA
operating
A sinusoidal wave is applied
to the VCOH pin.
fIN = 130 MHz,
VIN = 0.15 VP-P
Note When the processor clock control register (PCC) is set to 00H and the oscillation mode selection register
(OSMS) is set to 01H
Remark TCY: Cycle time (minimum instruction execution time)
85