English
Language : 

PD178016GC-051_15 Datasheet, PDF (16/96 Pages) Renesas Technology Corp – 8-BIT SINGLE-CHIP MICROCONTROLLER WITH BUILT-IN PRESCALER, PLL FREQUENCY SYNTHESIZER, AND IF COUNTER FOR AUTOMOTIVE FM/MW/LW RADIO APPLICATIONS
µPD178016GC-051
Pin No. Symbol
Pin name
66
DEV_LEVEL Modulation signal
input
Description
Input pin for the modulation signal.
Input the signal as indicated in the table below.
I/O type
Input
67
CD IN
68
BATT
CD changer data
input
BATT signal input
DEV_LEVEL pin
0
Mute
1
Sound
Input pin for the CD changer data.
Description
(0: Low, 1: High)
Input pin for the BATT signal.
Input the signal as indicated in the table below.
Input
Input
69
ACC
ACC signal input
BATT pin
Description
0
Power OFF
1
Power ON
(0: Low, 1: High)
In no-clock mode (initial setting diode NOCLK = 1) or a mode in
which the clock is not counted during power off (initial setting diode
CTOFF = 1), the power consumption is reduced during power off.
Input pin for the ACC signal.
Input the signal as indicated in the table below.
Input
ACC pin
Description
0
Power OFF
1
Power ON
(0: Low, 1: High)
In no-clock mode (initial setting diode NOCLK = 1) or a mode in
which the clock is not counted during power off (initial setting diode
CTOFF = 1), the power consumption is reduced during power off.
70
PANEL Panel detachment Input pin used to detect whether the front panel has been detached. Input
detection input
The input of a high-level signal indicates that the front panel has
been detached.
71
REMIN Remote-controller
Remote-controller signal input pin.
signal input
Input
72
RDSCLK RDS clock input
RDS clock input pin. To this pin, input the clock signal from the
RDS signal detector section.
Because the µPD178016GC-051 does not detect bit
synchronization based on the width of a clock signal, the input
clock signal must be as accurate as possible.
Input
73
RDSDATA RDS data input
Input pin for RDS data. To this pin, input the data signal from the
RDS signal detector section.
Data is read at the falling edge of an RDS clock pulse.
Input
74
REGCPU CPU power supply Regulator pin for CPU power supply.
—
regulator
Connect this pin to ground via a 0.1-µF capacitor.
75
GND
Ground
Device ground
—
14