HD49334ANP Datasheet, PDF (8/22 Pages) Renesas Technology Corp – CDS/PGA & 10-bit A/D Converter

HD49334ANP/AHNP
7. Adjustment of Black-Level S/H Response Frequency Characteristics
The CR time constant that is used for sampling/hold (S/H) at the black level can be adjusted by changing the register
settings, as shown in table 6.
Table 6 SHSW CR Time Constant Setting
SHSW-fsel (Register setting)
[0] [1] [2] [3] [0] [1] [2] [3] [0] [1] [2] [3] [0] [1] [2] [3] [0] [1] [2] [3] [0] [1] [2] [3] [0] [1] [2] [3] [0] [1] [2] [3]
L L L LHL L L LHL LHHL L L LHLHLHL LHHLHHHL
CR Time Constant (Typ) 2.20 nsec 2.30 nsec 2.51 nsec 2.64 nsec 2.93 nsec 3.11 nsec 3.52 nsec 3.77 nsec
(cutoff frequency conversion) (72 MHz) (69 MHz) (63 MHz) (60 MHz) (54 MHz) (51 MHz) (45 MHz) (42 MHz)
SHSW-fsel (Register setting)
[0] [1] [2] [3] [0] [1] [2] [3] [0] [1] [2] [3] [0] [1] [2] [3] [0] [1] [2] [3] [0] [1] [2] [3] [0] [1] [2] [3] [0] [1] [2] [3]
L L LHHL LHLHLHHHLHL LHHHLHHLHHHHHHH
CR Time Constant (Typ) 4.40 nsec 4.80 nsec 5.87 nsec 6.60 nsec 8.80 nsec 10.6 nsec 17.6 nsec 26.4 nsec
(cutoff frequency conversion) (36 MHz) (33 MHz) (27 MHz) (24 MHz) (18 MHz) (15 MHz) (9 MHz) (6 MHz)
8. The SHAMP frequency characteristics can be adjusted by changing the register settings
and the C4 value of the external 23rd pin.
The settings are shown in table 7.
Values other than those shown in the table 7 cannot be used.
BLKC
23
C4
Table 7 SHAMP Frequency Characteristics Setting
LoPwr
[0]
(Register setting)
H
SHA-fsel (Register setting)
[1]
[0]
[1]
L
L
H
"Lo"
116 MHz
10000 pF
(270 pF)
75 MHz
13000 pF
(300 pF)
"Hi"
49 MHz
15000 pF
(620 pF)
32 MHz
22000 pF
(750 pF)
Note: Upper line : SHAMP cutoff frequency (Typ)
Middle line : Standard value of C4 (maximum value is not defined)
Lower line : Minimum value of C4 (do not set below this value)
[0]
[1]
H
H
56 MHz
18000 pF
(360 pF)
24 MHz
27000 pF
(820 pF)
Rev.2.00 May 20, 2005 page 8 of 21