H8S18 Datasheet, PDF (628/758 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2200 Series

Section 17 Flash Memory (F-ZTAT Version)
• Overview
When a reset start preformed after the pins of this LSI have been set to boot mode, a boot
program incorporated in the microcomputer beforehand is activated, and the prepared
programming control program is transmitted sequentially to the host using the USB. With this
LSI, the programming control program received by the USB is written to a programming
control program area in on-chip RAM. After transfer is completed, control branches to the start
address of the programming control program area, and the programming control program
execution state is established (flash memory programming is performed). Figure 17.9 shows a
system configuration diagram when using USB boot mode.
0
EMLE
1
FWE*
01×
MD2 to MD0*
This LSI
Host or
self-powerd HUB
P36
Flash memory
1.5kΩ
D+
Rs
USD+
Data transmission/reception
USB
D-
USD-
Rs
VBUS
On-chip RAM
EXTAL
XTAL
UBPM
System clock:
16 MHz or 24MHz
1: Self power setting
0: Bus power setting
Legend:
×: Don’t care
Note: * FWE pin and mode pin input must satisfy the mode programming setup time (t_MDS = 200ns) when a reset is released.
Figure 17.9 System Configuration Diagram when Using USB Boot Mode
Table 17.7 shows operations from reset release in USB boot mode until processing branches to
the programming control program.
1. When boot mode is used, the flash memory programming control program must be prepared in
the host beforehand. Prepare a programming control program in accordance with the
description in section 17.8, Flash Memory Programming/Erasing. In boot mode, if any data has
been programmed into the flash memory (if all data is not 1), all flash memory blocks are
erased. Boot mode is for use in enforced exit when user program mode is unavailable, such a
the first time on-board programming control program, or performed, or if the program
activated in user program mode is accidentally erased.
2. When the boot program is activated, enumeration with respect to the host is carried out.
Enumeration information is shown in table 17.6. When enumeration is completed, transmit a
single H'55 byte from the host. If reception has not been preformed normally, restart boot mode
by means of a reset.
Rev.7.00 Dec. 24, 2008 Page 572 of 698
REJ09B0074-0700