|
R01DS0012EJ0110_15 Datasheet, PDF (6/70 Pages) Renesas Technology Corp – RENESAS MCU | |||
|
◁ |
R8C/34W Group, R8C/34X Group, R8C/34Y Group, R8C/34Z Group
1. Overview
Table 1.5 Specifications for R8C/34Y Group (1)
Item
Function
Specification
CPU
Central processing R8C CPU core
unit
⢠Number of fundamental instructions: 89
⢠Minimum instruction execution time:
50 ns (f(XIN) = 20 MHz, VCC = 2.7 to 5.5 V)
⢠Multiplier: 16 bits à 16 bits â 32 bits
⢠Multiply-accumulate instruction: 16 bits à 16 bits + 32 bits â 32 bits
⢠Operating mode: Single-chip mode (address space: 1 Mbyte)
Memory
ROM, RAM, Data Refer to Table 1.11 Product List for R8C/34Y Group.
flash
Power Supply Voltage detection ⢠Power-on reset
Voltage
circuit
⢠Voltage detection 3 (detection level of voltage detection 1 selectable)
Detection
I/O Ports
Programmable I/O ⢠Input-only: 1 pin
ports
⢠CMOS I/O ports: 43, selectable pull-up resistor
Clock
Clock generation 3 circuits: XIN clock oscillation circuit (with on-chip feedback resistor),
circuits
High-speed on-chip oscillator (with frequency adjustment function),
Low-speed on-chip oscillator
⢠Oscillation stop detection: XIN clock oscillation stop detection function
⢠Frequency divider circuit: Dividing selectable 1, 2, 4, 8, and 16
⢠Low power consumption modes:
Standard operating mode (high-speed clock, high-speed on-chip oscillator,
low-speed on-chip oscillator), wait mode, stop mode
Interrupts
⢠Interrupt vectors: 69
⢠External: 9 sources (INT à 5, key input à 4)
⢠Priority levels: 7 levels
Watchdog Timer
⢠14 bits à 1 (with prescaler)
⢠Reset start selectable
⢠Low-speed on-chip oscillator for watchdog timer selectable
DTC (Data Transfer Controller)
⢠1 channel
⢠Activation sources: 31
⢠Transfer modes: 2 (normal mode, repeat mode)
Timer
Timer RA
8 bits (with 8-bit prescaler) Ã 1
Timer mode (period timer), pulse output mode (output level inverted every
period), event counter mode, pulse width measurement mode, pulse period
measurement mode
Timer RB
8 bits (with 8-bit prescaler) Ã 1
Timer mode (period timer), programmable waveform generation mode (PWM
output), programmable one-shot generation mode, programmable wait one-
shot generation mode
Timer RC
16 bits (with 4 capture/compare registers) Ã 1
Timer mode (input capture function, output compare function), PWM mode
(output 3 pins), PWM2 mode (PWM output pin)
Timer RD
16 bits (with 4 capture/compare registers) Ã 2
Timer mode (input capture function, output compare function), PWM mode
(output 6 pins), reset synchronous PWM mode (output three-phase
waveforms (6 pins), sawtooth wave modulation), complementary PWM mode
(output three-phase waveforms (6 pins), triangular wave modulation), PWM3
mode (PWM output 2 pins with fixed period)
Timer RE
8 bits à 1
Output compare mode
R01DS0012EJ0110 Rev.1.10
Jan 31, 2013
Page 6 of 67
|
▷ |