M16C64A_15 Datasheet, PDF (47/92 Pages) Renesas Technology Corp – RENESAS MCU

M16C/64A Group
5. Electrical Characteristics
5.1.6 Voltage Detector and Power Supply Circuit Electrical Characteristics
Table 5.11 Voltage Detector 0 Electrical Characteristics
The measurement condition is V_CC1 = 2.7 to 5.5 V, T_opr = -20°C to 85°C/-40°C to 85°C, unless otherwise specified.
Symbol
Parameter
Condition
Standard
Unit
Min. Typ. Max.
V_det0
Voltage detection level Vdet0_0 ⁽¹⁾
When V_CC1 is falling.
1.60 1.90 2.20 V
Voltage detection level Vdet0_2 ⁽¹⁾
When V_CC1 is falling.
2.55 2.85 3.15 V
-
Voltage detector 0 response time ⁽³⁾
When V_CC1 falls from 5 V
to (Vdet0_0 - 0.1) V
200 μs
-
Voltage detector self power consumption
VC25 = 1, V_CC1 = 5.0 V
1.8
μA
t_d(E-A)
Waiting time until voltage detector operation
starts ⁽²⁾
100 μs
Notes:
1. Select the voltage detection level with the VDSEL1 bit in the OFS1 address.
2. Necessary time until the voltage detector operates when setting to 1 again after setting the VC25 bit in the VCR2
register to 0.
3. Time from when passing the V_det0 until when a voltage monitor 0 reset is generated.
Table 5.12 Voltage Detector 1 Electrical Characteristics
The measurement condition is V_CC1 = 2.7 to 5.5 V, T_opr = -20°C to 85°C/-40°C to 85°C, unless otherwise specified.
Symbol
Parameter
Condition
Standard
Unit
Min. Typ. Max.
V_det1
Voltage detection level Vdet1_6 ⁽¹⁾
When V_CC1 is falling.
2.79 3.09 3.39 V
Voltage detection level Vdet1_B ⁽¹⁾
When V_CC1 is falling.
3.54 3.84 4.14 V
Voltage detection level Vdet1_F ⁽¹⁾
When V_CC1 is falling.
3.94 4.44 4.94 V
-
Hysteresis width when V_CC1 of voltage detector
1 is rising
0.15
V
-
Voltage detector 1 response time ⁽³⁾
When V_CC1 falls from 5 V
to (Vdet1_0 - 0.1) V
200 μs
-
Voltage detector self power consumption
VC26 = 1, V_CC1 = 5.0 V
1.8
μA
t_d(E-A)
Waiting time until voltage detector operation
starts ⁽²⁾
100 μs
Notes:
1. Select the voltage detection level with bits VD1S0 to VD1S3 in the VD1LS register.
2. Necessary time until the voltage detector operates when setting to 1 again after setting the VC26 bit in the VCR2
register to 0.
3. Time from when passing the V_det1 until when a voltage monitor 1 reset is generated.
R01DS0032EJ0200 Rev.2.00
Feb 07, 2011
Page 47 of 88