R0E572167CFK10E Datasheet, PDF (31/54 Pages) Renesas Technology Corp – Microcomputer Development Environment System

Section 3 Connection Procedures
3.2.2 Connecting User System Interface Board to EV-Chip Unit
WARNING
Observe the precautions listed below. Failure to do so will
result in a FIRE HAZARD and will damage the user system and
the emulator product or will result in PERSONAL INJURY. The
USER PROGRAM will be LOST.
1. Always switch OFF the user system and the emulator
product before connecting the COMMON USER-SYSTEM
INTERFACE ADAPTOR CABLE to or removing it from any
part. Before connecting the cable, make sure that the pin
1 positions on both sides are correctly aligned.
2. Use the common user-system interface adaptor cable that
is specifically for the emulator.
1. Make sure the user system and emulator are turned off.
2. Align the connectors on the board with those on the EV-chip unit according to their numbers
(figure 5).
Rev. 1.00 Jul. 03, 2009 Page 13 of 32
REJ10J2025-0100