R0E572167CFK10E Datasheet, PDF (28/54 Pages) Renesas Technology Corp – Microcomputer Development Environment System

Section 3 Connection Procedures
3.2 Connection to the User System When the Flexible Cable is in Use
The IC socket on the user system is connected with the emulator in either of two ways
according to whether or not the flexible cable section of the common cable for the user system
interface is in use. Refer to this section (section 3.2, Connection with the Flexible Cable) or
section 3.3, Connection without the Flexible Cable according to whether or not the flexible
cable is in use.
While the flexible cable leads to longer delay times for generated signals to reach the device
from the IC socket, the area taken up on the emulator board for the user system is smaller. This
form of connection is thus applicable to a wider variety of layouts for the user system. Refer to
point 3 of section 5 for details on the delay time.
3.2.1 Assembling the User System Interface Cable
CAUTION
Check the location of pin 1 and the connector number before
insertion.
• Connecting the user system interface cable
Use the flexible cable section of the common cable for the user system interface to connect the
board section of the common cable for the user system interface with the user-system interface
converter board (see figure 3).
Rev. 1.00 Jul. 03, 2009 Page 10 of 32
REJ10J2025-0100