English
Language : 

M306V7MG_15 Datasheet, PDF (26/300 Pages) Renesas Technology Corp – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER
M306V7MG/MH/MJ/MJA-XXXFP, M306V7FG/FH/FJ/FJAFP
Processor mode register 0 (Note 1)
b7 b6 b5 b4 b3 b2 b1 b0
00
Symbol
PM0
Address
000416
When reset
0016 (Note 2)
Bit symbol
Bit name
PM00
Processor mode bit
PM01
PM02
PM03
R/W mode select bit
Software reset bit
PM04
PM05
Reserved bit
Function
b1 b0
0 0: Single-chip mode
0 1: Memory expansion mode
1 0: Inhibited
1 1: Microprocessor mode
RW
0 : RD,BHE,WR
1 : RD,WRH,WRL
The device is reset when this bit is set
to “1”. The value of this bit is “0” when
read.
Must always be set to “0”
PM06
Port P40 to P43 function
select bit (Note 3)
0 : Address output
1 : Port function
(Address is not output)
PM07
BCLK output disable bit
0 : BCLK is output
1 : BCLK is not output
(Pin is left floating)
Notes 1: Set bit 1 of the protect register (address 000A16) to “1” when writing new
values to this register.
2: If the VCC voltage is applied to the CNVSS, the value of this register when
reset is 0316. (PM00 and PM01 both are set to “1”.)
3: Valid in microprocessor and memory expansion modes.
Figure 2.4.1 Processor mode register 0
Rev.1.00 May 18, 2004 page 24 of 296