R1EV5801MB_16 Datasheet, PDF (15/22 Pages) Renesas Technology Corp – 1M EEPROM (128-Kword × 8-bit)Ready Busy and RES function

R1EV5801MB Series
Functional Description
Automatic Page Write
Page-mode write feature allows 1 to 128 bytes of data to be written into the EEPROM in a single write cycle.
Following the initial byte cycle, an additional 1 to 127 bytes can be written in the same manner. Each additional byte
load cycle must be started within 30 µs from the preceding falling edge of WE or CE. When CE or WE is kept high for
100 µs after data input, the EEPROM enters write mode automatically and the input data are written into the EEPROM.
Data Polling
Data polling allows the status of the EEPROM to be determined. If EEPROM is set to read mode during a write cycle,
an inversion of the last byte of data to be loaded outputs from I/O7 to indicate that the EEPROM is performing a write
operation.
RDY/Busy Signal
RDY/Busy signal also allows status of the EEPROM to be determined. The RDY/Busy signal has high impedance
except in write cycle and is lowered to V_OL after the first write signal. At the end of write cycle, the RDY/Busy signal
changes state to high impedance.
RES Signal
When RES is low, the EEPROM cannot be read or programmed. Therefore, data can be protected by keeping RES low
when V_CC is switched. RES should be high during read and programming because it doesn’t provide a latch function.
V_CC
Read inhibit
Read inhibit
RES
Program inhibit
Program inhibit
WE, CE Pin Operation
During a write cycle, addresses are latched by the falling edge of WE or CE, and data is latched by the rising edge of
WE or CE.
Write/Erase Endurance and Data Retention Time
The endurance is 10⁴ cycles (1% cumulative failure rate). The data retention time is more than 10 years.
R10DS0209EJ0200 Rev.2.00
May 12, 2016
Page 15 of 20