UPD78F9202MA-CAC-A Datasheet, PDF (101/342 Pages) Renesas Technology Corp – 8-Bit Single-Chip Microcontrollers

CHAPTER 6 16-BIT TIMER/EVENT COUNTER 00 (μPD78F920x ONLY)
Caution
6. When the TOE00 is 0, set the TOE00, LVS00, and LVR00 at the same time with the 8-bit
memory manipulation instruction. When the TOE00 is 1, the LVS00 and LVR00 can be set
with the 1-bit memory manipulation instruction.
(4) Prescaler mode register 00 (PRM00)
This register is used to set the 16-bit timer counter 00 (TM00) count clock and the TI000, TI010 pin input valid
edges.
PRM00 is set by a 1-bit or 8-bit memory manipulation instruction.
Reset signal generation sets the value of PRM00 to 00H.
Figure 6-8. Format of Prescaler Mode Register 00 (PRM00)
Address: FF61H After reset: 00H R/W
Symbol
7
6
5
4
3
PRM00
ES110
ES100
ES010
ES000
0
2
1
0
0
PRM001 PRM000
ES110
0
0
1
1
ES100
0
1
0
1
TI010 pin valid edge selection
Falling edge
Rising edge
Setting prohibited
Both falling and rising edges
ES010
0
0
1
1
ES000
0
1
0
1
TI000 pin valid edge selection
Falling edge
Rising edge
Setting prohibited
Both falling and rising edges
PRM001
0
0
1
1
PRM000
0
1
0
1
fXP (10 MHz)
fXP/2² (2.5 MHz)
fXP/2⁸ (39.06 kHz)
TI000 pin valid edge^Note
Count clock (fsam) selection
Remarks 1. fXP: Oscillation frequency of clock supplied to peripheral hardware
2. ( ): fXP = 10 MHz
Note The external clock requires a pulse longer than two cycles of the internal count clock (fXP).
Cautions 1. Always set data to PRM00 after stopping the timer operation.
2. If the valid edge of the TI000 pin is to be set as the count clock, do not set the clear/start
mode and the capture trigger at the valid edge of the TI000 pin.
User’s Manual U18172EJ3V0UD
99