H8S2472 Datasheet, PDF (1008/1250 Pages) Renesas Technology Corp – 16-Bit Single-Chip Microcomputer H8S Family / H8S/2400 Series

Section 25 Flash Memory
11. The parameter which is required for programming is set.
The start address of the programming destination of the user MAT (FMPAR) is set to general
register ER1. The start address of the program data area (FMPDR) is set to general register
ER0.
 Example of the FMPAR setting
FMPAR specifies the programming destination address. When an address other than one in
the user MAT area is specified, even if the programming program is executed,
programming is not executed and an error is returned to the return value parameter FPFR.
Since the unit is 128 bytes, the lower eight bits of the address must be H'00 or H'80 as the
boundary of 128 bytes.
 Example of the FMPDR setting
When the storage destination of the program data is flash memory, even if the program
execution routine is executed, programming is not executed and an error is returned to the
FPFR parameter. In this case, the program data must be transferred to the on-chip RAM
and then programming must be executed.
12. Programming
There is an entry point of the programming program in the area from the start address specified
by FTDAR + 16 bytes of the on-chip RAM. The subroutine is called and programming is
executed by using the following steps.
MOV.L
JSR
NOP
#DLTOP+16,ER2
@ER2
; Set entry address to ER2
; Call programming routine
 The general registers other than R0L are held in the programming program.
 R0L is a return value of the FPFR parameter.
 Since the stack area is used in the programming program, a stack area of 128 bytes at the
maximum must be allocated in RAM.
13. The return value in the programming program, FPFR (general register R0L) is determined.
14. Determine whether programming of the necessary data has finished.
If more than 128 bytes of data are to be programmed, specify FMPAR and FMPDR in 128-
byte units, and repeat steps 12 to 14. Increment the programming destination address by 128
bytes and update the programming data pointer correctly. If an address which has already been
programmed is written to again, not only will a programming error occur, but also flash
memory will be damaged.
Rev. 2.00 Aug. 20, 2008 Page 960 of 1198
REJ09B0403-0200