CD10.241 Datasheet, PDF (7/25 Pages) PULS GmbH – DC/DC Converter 24V/24V, 10A, 240W

CD-Series
CD10.241
DC/DC Converter 24V/24V, 10A, 240W
6. HOLD-UP TIME
The input side of the DC/DC converter is equipped with a bulk capacitor which keeps the output voltage alive for a
certain period of time when the input voltage dips or is removed. The bulk capacitor can be discharged by loading the
DC/DC converter on the output side or through a load which is parallel to the input. There is no protection in the
DC/DC converter which prevents current from flowing back to the input terminals. If prevention is needed, an external
diode should be used.
Hold-up Time
typ.
8ms
at 24Vdc input and 24Vdc, 5A output, see Fig. 6-1
typ.
4ms
at 24Vdc input and 24Vdc, 10A output, see Fig. 6-1
Fig. 6-1 Hold-up time vs. input voltage
Hold-up Time
8ms
6
(a) (b)
(c)
4
(d)
2
0
18
Input Voltage
(a) 24V, 5A, typ.
(b) 24V, 5A, min.
(c) 24V, 10A, typ.
(d) 24V, 10A, min.
20
22
24
26 28Vdc
Fig. 6-2 Shut-down test setup
S1
+
DC
Source
-
DC/DC
Converter
Input ₊
CD10
Output ^-
+
Load
-
Fig. 6-3 Shut-down behavior, definitions
Intput
Voltage
S1 opens
Output
Voltage
Hold-up Time
- 5%
Note: At no load, the hold-up time can be up to several seconds. The green DC-ok lamp is also on during this time.
Jul. 2017 / Rev. 1.1 DS-CD10.241-EN All parameters are typical values at 24V, 10A, 24Vdc input voltage, 25°C ambient and
after a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone [phone] Germany
7/25