CD10.241 Datasheet, PDF (10/25 Pages) PULS GmbH – DC/DC Converter 24V/24V, 10A, 240W

CD-Series
CD10.241
DC/DC Converter 24V/24V, 10A, 240W
10. TERMINALS AND WIRING
Type
Solid wire
Stranded wire
American Wire Gauge
Max. wire diameter
Wire stripping length
Screwdriver
Recommended tightening torque
Input
screw terminals
max. 6mm²
max. 4mm²
20-10 AWG
2.8mm (including ferrules)
7mm / 0.275inch
3.5mm slotted or
Pozidrive No 2
1Nm, 9lb.in
Output
screw terminals
max. 6mm²
max. 4mm²
20-10 AWG
2.8mm (including ferrules)
7mm / 0.275inch
3.5mm slotted or
Pozidrive No 2
1Nm, 9lb.in
Instructions:
a) Use appropriate copper cables that are designed for an operating temperature of:
60°C for ambient up to 45°C and
75°C for ambient up to 60°C and
90°C for ambient up to 70°C minimum.
b) Follow national installation codes and installation regulations!
c) Ensure that all strands of a stranded wire enter the terminal connection!
d) Screws of unused terminal compartments should be securely tightened.
Daisy chaining of outputs:
Daisy chaining (jumping from one DC/DC-converter output to the next) is allowed as long as the average output
current through one terminal pin does not exceed 25A. If the current is higher, use a separate distribution terminal
block.
Fig. 10-1 Daisy chaining of outputs
max 25A!
Output
++- -
DC/DC
Converter
Output
++- -
DC/DC
Converter
+-
Load
Input
Input
Fig. 10-2 Using distribution terminals
Output
++- -
Output
++- -
DC/DC
DC/DC
Converter Converter
+-
Load
Input
Input
Distribution
Terminals
Jul. 2017 / Rev. 1.1 DS-CD10.241-EN All parameters are typical values at 24V, 10A, 24Vdc input voltage, 25°C ambient and
after a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone [phone] Germany
10/25