PAS395 Datasheet, PDF (13/14 Pages) PULS GmbH – Charger for EDLC Capacitors (Ultra-Caps)

14 Terminals and Wiring
Two self-locking plug-connectors (X1, X2) with spring-clamp connection points
Pin assignment:
X1: Power Connector
1 Vout (+)
2 not used
3 Vout (-)
4 not used
5 PE
6N
7L
X2: Signal Connector
1 Inhibit (+)
2 Inhibit (-)
3 Fully charged contact
4 Fully charged contact
5 Output-OK contact
6 Output-OK contact
Cross section
0.08 - 2.5 mm² (solid)
0.08 - 2.5 mm² (fine-stranded)
0.25 - 1.5 mm² (fine-stranded with ferrule and plastic collar)
0.25 - 2.5 mm² (fine-stranded with ferrule, without plastic collar)
28 - 12 AWG
Recommended stripping length: 8 - 9mm (0.31 - 0.35in)
This document is proprietary. Any dispatch or disclosure of content is authorized only after written authorization by PULS GmbH.
All parameters are specified at 400V, 2.5A, 230Vac, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.
Specification: SP-PAS395 Rev: 3.1
Date: 2013/01/19
13-14