CM1400DUC-24S Datasheet, PDF (4/6 Pages) Mitsubishi Electric Semiconductor – HIGH POWER SWITCHING USE INSULATED TYPE

Powerex, Inc., 173 Pavilion Lane, Youngwood, Pennsylvania 15697 [phone] www.pwrx.com
CM1400DUC-24S
Mega Power Dual IGBT
1400 Amperes/1200 Volts
Electrical Characteristics, T_j = 25°C unless otherwise specified (continued)
Thermal Resistance Characteristics
Thermal Resistance, Junction to Case^*4
Thermal Resistance, Junction to Case^*4
Contact Thermal Resistance,
R_th(j-c)Q
R_th(j-c)D
R_th(c-f)
Case to Heatsink
Per Inverter IGBT
Per Inverter Diode
Thermal Grease Applied
(Per 1 Module)^*7
—
—
16
K/kW
—
—
26
K/kW
—
6
—
K/kW
Mechanical Characteristics
Mounting Torque
Creepage Distance
M_t
Main Terminals, M6 Screw
22
27
31
in-lb
M_s
Mounting to Heatsink, M6 Screw
22
27
31
in-lb
d_s
Terminal to Terminal
24
—
—
mm
Terminal to Baseplate
33
—
—
mm
Clearance
d_a
Terminal to Terminal
14
—
—
mm
Terminal to Baseplate
33
—
—
mm
Weight
Flatness of Baseplate
m
—
1450
— Grams
e_c
On Centerline X, Y^*5
-50
—
+100
µm
Recommended Operating Conditons, T_a = 25°C
(DC) Supply Voltage
Gate-Emitter Drive Voltage
External Gate Resistance
V_CC
V_GE(on)
R_G
Applied Across P-N
Applied Across G-Es
Per Switch
*4 Case temperature (T_C) and heatsink temperature (T_s) is measured on the surface
(mounting side) of the baseplate and the heatsink side just under the chips.
Refer to the figure to the right for chip location.
The heatsink thermal resistance should be measured just under the chips.
*5 Baseplate (mounting side) flatness measurement points (X, Y) are shown in the figure below.
39 mm
39 mm
116.0
Tr2 Di2
—
600
13.5 15.0
0
—
Di1 Tr1
BOTTOM
LABEL SIDE
BOTTOM
Y1
Y2
X
BOTTOM
– CONCAVE
+ CONVEX
96.4
74.5
54.9
33.0
13.4
0
Tr2 Di2
Tr2 Di2
Tr2 Di2
Tr2 Di2
Tr2 Di2
Di1 Tr1
Di1 Tr1
Di1 Tr1
Di1 Tr1
Di1 Tr1
*7 Typical value is measured by using thermally conductive grease of λ = 0.9 [W/(m • K)].
LABEL SIDE
Tr1, Tr2: IGBT, Di1, Di2: FWDi
Each mark points to the center position of each chip.
850
16.5
2.2
Volts
Volts
Ω
4
09/12 Rev. 0